Operation Manual

13
IF...
My items are not recharging or the
compact tire inator is not inating.
I haven’t used my booster MPB-12000
in a while, and now the unit is com-
pletely drained.
TRY THIS...
Recharge the booster MPB-12000.
Verify that your items are correctly connect-
ed
You may have accidentally put it away with
it powered on. Recharge it.
1 LED light
2 Screw valve
8 adapters
3 4 inch Air Hose
4 Manometer
(PSI/bar/KPA)
7 ON/OFF button
5 Plug cord
6 Connector
This compact tire inator is intended for short run use. Maximum running time should not
exceed 15 minutes and a 15 minute cool-down period is recommended before running the
compressor again.
USING THE COMPACT TIRE INFLATOR
The compact tire inator comes equipped to add air to car tires. It also includes air needle adapters for
adding air to bicycle tires, sports balls, etc.
1. Connect the connector (6) of then compact tire inator to the 12 V connector (8) of then booster MPB-
12000.
2. Connect the appropriate air needle adapter (8) to the compact tire inator if needed.
3. Connect the screw valve (2) of the compact tire inator to item to inate.
4. Press the ON/OFF button (7) on the compact tire inator.
5. Stop inating occasionally to check the air pressure on the manometer and to be sure not to overin-
ate your item.
6. Press the ON/OFF button (7) again when the item is inated to turn off the compact tire inator.
The tire inator works even if the slide ON/OFF (7) of the booster MPB-12000 is not “ON”.
TROUBLESHOOTING
MAINTENANCE
Use common sense when caring for your MPB-12000. Be sure the connectors and jacks remain clean
and free of debris. Unplug the MPB-12000 after charging. Store the MPB-12000 and its accessories in
the carrying case provided.