Operation Manual

13
REMOVE (See the figure 2)
2-1: To remove the battery pack, pull down the release latch on bottom.
2-2: Slide the battery pack away form the transceiver.
19) Frequency Display
It is possible to set Frequency Display function on or off.
When active, at standby mode, press F (3) button shows
the frequency of the channel.
F) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels : 40
- Modulation modes : AM / FM
- Frequency ranges : from 26.965 MHz to 27.405 MHz
- Antenna impedance : 50 ohms
- Power supply : 13.2 V (Randy II M) / 7.4 V (Randy II P)
- Dim ens ion s (i n mm) : 54 (W) x 35 (D) x 120 (H) without accessories
- Weight : 319 g with accessories (Randy II M)
357 g with accessories (Randy II P)
- Accessories supplied : Adapter with antenna connector and
cigarette lighter plug (Randy II M)
Battery, rubber antenna and wall charger
(Randy II P)
- Filter : ANL (Automatic Noise Limiter)
2) TRANSMISSION
- Frequency allowance : +/- 200 Hz
- Carrier power : 1 ~ 3 W AM / 1 ~ 4 W FM
- Transmission interference : inferior to 4 nW (- 54 dBm)
- Audio response : 300 Hz to 2.5 KHz
- Emitted power in the adj. channel : inferior to 20 µW
- Microphone sensitivity : 7 mV
- Drain : 1,8 A (with modulation power Hi)
- Modulated signal distortion : 2 %
3) RECEPTION
- Maxi. sensitivity at 20 dB sinad : AM: 0.5 µV - 113 dBm / FM : 0.3 µV - 116 dBm
- Frequency response : 300 Hz to 2.5 kHz
- Adjacent channel selectivity : 60 dB
- Maximum audio power : 1 W
- Squelch sensitivity : min : 0.2 µV - 120 dBm / max : 1 mV - 47 dBm
- Internal speaker : 8 ohms, 1 W