Operation Manual

ManualsBrandsPresident ManualsAudioTommy

a) ASC: AUTOMATIC SQUELCH CONTROL

Worldwide patent, a PRESIDENT exclusivity.

Turn the SQ knob (3) anti-clockwise into ASC position. «ASC» appears on the display. No

repetitive manual adjustment and a permanent improvement between the sensitivity

and the listening comfort when ASC is active. This function can be disconnected by

turning the switch clockwise. In this case the squelch adjustment becomes manual

again. «ASC» disappears from the display.

b) MANUAL SQUELCH

Turn the SQ knob clockwise to the exact point where all background noise disappears.

This adjustment should be done with precision as, if set to maximum (fully clockwise),

only the strongest signals will be received.

4) CHANNEL SELECTOR: Rotary Knob

This button allow increasing or decreasing a channel. A «beep» sounds each time

the channel changes if the KEY BP function is activated. See KEY BP function.

5) F ~ KEY BP

F - FREQUENCY BAND SELECTION

(conﬁguration: E; d; EU; PL)

The frequency bands have to be chosen according to the country of use. Don’t use

any other conﬁguration. Some countries need a user’s licence.

See table page 51.

Proceeding: switch off the transceiver. Keep the key F pressed and switch on again.

and the letter corresponding to the conﬁguration are blinking.

- In order to change the conﬁguration, use the channel selector on the front panel.

- When the conﬁguration is selected, press 1 second on the F key.

and the letter

corresponding to the conﬁguration are continuously displayed, a beep sounds. At

this point, conﬁrm the selection by switching off the transceiver and then switching

it on again.

See the conﬁgurations / frequency bands table pages 48 to 50.

KEY BP Beep on changing the channel, keys etc... (long press)

Activate the KEY BP function by pressing 1 second the KEY BP key. A beep sounds

and «BP» is displayed. In order to disable the function, press during 1 second the KEY

BP key. «BP» disappears.

6) LOCK

Allows to lock all the keys on the front panel and the rotary knob. An error beep

sounds when a key is used and the LOCK function is activated. A short press on

LOCK activates/deactivates the LOCK function.

appears on the display when

the function is activated.

Transmission and reception remain active.

7) 6 PIN MICROPHONE PLUG

The plug is located on the front panel of the transceiver and makes the setting of

the equipment into the dashboard easier.

See cabling diagram page 49.

8) PTT

Transmission key, press to transmit a message, is displayed and release to listen

to an incoming communication.

English