User Manual

7
2 Hookup
2.2 Back Panel Connections
Studio 192 and Studio 192 Mobile
Owner’s Manual
Line Output 1-8/4. The Studio 192-series interfaces have eight/four line
balanced line outputs to route to external devices, such as headphone
amps, signal processors, and additional monitors. Each output has
an independent playback stream (playback streams 3-10/6).
Main Outs. These are the main outputs for the Studio 192-series interface. The
output level of the Main Outputs is controlled by the Main level control on the front
of the unit. Like the line outputs, the main outputs have independent playback
streams (playback streams 1-2).
Clock In and Out. These BNC connections allow the Studio 192-series interface to
receive and transmit word clock to and from other digital audio devices.
Power User Tip: In UC Surface, when using the BNC Clock input, you will need to set
“BNC” as the Clock Source and set the sample rate to correspond to that of the external
device. See Section 4.6 for details. A 75Ω BNC word clock cable is required to achieve
proper sync.
S/PDIF In and Out. The S/PDIF connections allow two channels of audio to be
transmitted and received at rates up to 24-bit, 96 kHz. The S/PDIF I/O also allows
the Studio 192-series interfaces to send and receive word clock to external
digital devices.
Power User Tip: In UC Surface, you will need to set “S/PDIF” as the Clock Source and the
sample rate to correspond to the external device when using an external S/PDIF device as
your master clock. See Section 4.6 for details.