User Manual
Table Of Contents
- 1 Overview
- 1.1 Introduction
- 1.2 Product Registration
- 1.3 What’s in the box
- 1.4 What’s in your MyPreSonus account
- 1.5 Companion PreSonus Products
- 1.6 Firmware Updates
- 2 Standard Controller Mode
- 2.1 Setup Mode
- 2.2 Pads
- 2.2.1 RGB Colors
- 2.2.2 Triggering Notes
- 2.2.3 Plus and Minus Pads
- 2.3 Touch Strip
- 2.4 A-H Buttons
- 2.5 Knobs 1-8
- 2.6 Navigation Buttons
- 2.7 Transport Buttons
- 2.8 Screen Controls
- 2.8.1 Instrument Mode
- 2.8.2 Song Mode
- 2.8.3 Editor Modes
- 2.8.4 User Mode
- 3 Advanced Studio One Integration
- 3.1 Controls
- 3.1.1 Pad Controllers
- 3.1.2 Touch Strip
- 3.1.3 A-H Buttons
- 3.1.4 Encoders
- 3.1.5 Navigation Buttons
- 3.1.6 Transport Buttons
- 3.1.7 Global Controls
- 3.2 Screen Controls
- 3.2.1 Instrument Mode
- 3.2.2 Song Mode
- 3.2.3 Editor Modes
- 3.2.4 User Mode
- 4 Advanced Ableton Live Integration
- 4.1 Control Functions
- 4.1.1 RGB Colors
- 4.1.2 Triggering Notes or Clips
- 4.1.3 Plus and Minus Pads
- 4.1.4 Touch Strip
- 4.1.5 A-H Buttons
- 4.1.6 Knobs 1-8
- 4.1.7 Navigation Buttons
- 4.1.8 Transport Buttons
- 4.2 Screen Controls
- 4.2.1 Instrument Mode
- 4.2.2 Song Mode
- 4.2.3 Editor Mode
- 4.2.4 User Mode
- 5 Studio One Artist Quick Start
- 5.1 Installation and Authorization
- 5.2 Setting Up Studio One
- 5.2.1 Configuring Audio Devices
- 5.2.2 Configuring MIDI Devices
- 5.3 Creating a New Song
- 5.3.1 Configuring Your Audio I/O
- 5.3.2 Creating Audio and Instrument Tracks
- 5.3.3 Recording an Audio Track
- 5.3.4 Adding Virtual Instruments and Effects
47
5 Studio One Artist Quick Start
5.3 Creating a New Song
ATOM SQ
Owner’s Manual
2. Click on the Audio I/O Setup tab.
3. From the Inputs tab, you can enable any or all of the inputs on your
audio interface that you’d like to have available. We recommend that you
create a mono input for each of the inputs on your interface. If you plan
on recording in stereo, you should also create a few stereo inputs.
4. Click on the Outputs tabs to enable any or all of the outputs on your
audio interface. In the lower right corner, you will see the Audition
Select menu. This allows you to choose the output from which you
will audition audio files prior to importing them into Studio One
Artist. In general, you will want this to be the main output bus.
Power User Tip: If you would like this I/O configuration to be the same every time you
open Studio One, click the Make Default button.