User`s manual

CONTROLS AND CONNECTIONS
38 | PreSonus 2008
 Clip indicator
Each meter is equipped with a clip signal. A red “C” will
illuminate when the track has clipped. To reset the meter, simply
click on the “C”.
Please note: The metering in the FireStudio Control Console is
completely independent of your host application. If an input
signal is clipping while being recorded, lowering the volume in the
FireStudio Control Console will not lower the volume in your
DAW application. Be sure to monitor your inputs in you DAW as
well as the monitor mixes you are creating in the FireStudio
Control Console. If a signal is clipping in your DAW, you must
adjust the physical trim pot on the face of the FireStudio.
 Link Button
The Link button joins outputs into stereo pairs. To enable this,
simply click on the word “LINK”. The letters will turn blue. To
separate the channels, click the word again. When channels are
linked, the volume of both will be controlled with either fader.
3.4.2 Master Fader
Each mix has its own master fader control independent of the Outputs / Router Matrix.
 Master Fader
The Master Fader for each Mix has all the same features as the
output faders on the Outputs / Router Matrix tab. For a complete
detailing of each feature, please review section 3.3.3