User's Manual
Table Of Contents
- 1 Overview
- 1.1 Introduction
- 1.2 Features
- 1.3 What’s in the Box
- 2 Getting Started
- 2.1 Quick Start Guide
- 2.1.1 Connecting the Monitor Station V2’s Power
- 2.1.2 Connecting Devices to the Monitor Station V2’s Inputs
- 2.1.3 Calibrating the Monitor Station V2’s LED Meter
- 2.1.4 Setting the Output Level of Your Audio Sources
- 2.1.5 Connecting Speakers to the Monitor Station V2
- 2.1.6 Calibrating Your Speaker Levels
- 2.1.7 Calibrate the Talkback Microphone
- 2.1.8 Connect the Cue Outputs
- 2.1.9 Connect the Main Outputs
- 2.2 Basic Hookup Diagram
- 2.3 Advanced Modes
- 2.3.1 Speaker Select Modes
- 2.3.2 Main and Cue Source Modes
- 2.3.3 Input LED Meter Modes
- 2.3.4 Reset All Modes to the Factory Default
- 3 Hookup
- 3.1 The Back Panel
- 3.1.1 Inputs
- 3.1.2 Speaker Outputs
- 3.1.3 Line Outputs
- 3.1.4 Power
- 4 Controls
- 4.1 The Front Panel
- 4.1.1 Talkback
- 4.1.2 Cue Control
- 4.1.3 Aux Control
- 4.1.4 Main Source Control
- 4.1.5 Speaker Control
- 4.1.6 Main Level Controls
- 5 Resources
- 5.1 Audio Specifications
- 5.2 Frequently Asked Questions
- 5.3 Troubleshooting
- 5.4 PreSonus Limited Warranty
2 Getting Started
2.1 Quick Start Guide
Monitor Station V2
Owner’s Manual
4
2.1.2 Connecting Devices to the Monitor Station V2’s Inputs
1. Zero the Monitor Station V2’s front-panel Main Output Level knob, the Cue Output
knob, and the individual headphone Level knobs by turning them fully
counterclockwise.
2. Connect your primary audio source (computer audio interface, mixer, or other
stereo source) to the balanced ¼” TRS ST1 L/R inputs on the back of your Monitor
Station V2.
3. If you have a secondary stereo audio source or cue audio source—such as other
interface outputs or the auxiliary outputs of your mixer—connect it to the
balanced ¼” TRS ST2 L/R inputs.
The Monitor Station V2 can accommodate a variety of analog
and digital input sources. Here’s how to attach them.
Phone, personal music player, or other device with 1/8” stereo output. Connect
the output to the rear-panel 1/8” Aux In jack using an unbalanced, stereo 1/8” cable.
(With a phone or personal music player, the headphone jack is its output.)
Analog audio device with RCA outputs. Connect the device’s outputs to the
Monitor Station V2’s rear-panel unbalanced RCA AUX L/R IN jacks.