Owners Manual
Table Of Contents
- 1 Overview
- 1.1 Introduction
- 1.2 Features
- 1.3 What’s in the Box
- 2 Getting Started
- 2.1 Quick Start Guide
- 2.1.1 Connecting the Monitor Station V2’s Power
- 2.1.2 Connecting Devices to the Monitor Station V2’s Inputs
- 2.1.3 Calibrating the Monitor Station V2’s LED Meter
- 2.1.4 Setting the Output Level of Your Audio Sources
- 2.1.5 Connecting Speakers to the Monitor Station V2
- 2.1.6 Calibrating Your Speaker Levels
- 2.1.7 Calibrate the Talkback Microphone
- 2.1.8 Connect the Cue Outputs
- 2.1.9 Connect the Main Outputs
- 2.2 Basic Hookup Diagram
- 2.3 Advanced Modes
- 2.3.1 Speaker Select Modes
- 2.3.2 Main and Cue Source Modes
- 2.3.3 Input LED Meter Modes
- 2.3.4 Reset All Modes to the Factory Default
- 3 Hookup
- 3.1 The Back Panel
- 3.1.1 Inputs
- 3.1.2 Speaker Outputs
- 3.1.3 Line Outputs
- 3.1.4 Power
- 4 Controls
- 4.1 The Front Panel
- 4.1.1 Talkback
- 4.1.2 Cue Control
- 4.1.3 Aux Control
- 4.1.4 Main Source Control
- 4.1.5 Speaker Control
- 4.1.6 Main Level Controls
- 5 Resources
- 5.1 Audio Specifications
- 5.2 Frequently Asked Questions
- 5.3 Troubleshooting
- 5.4 PreSonus Limited Warranty
2 Getting Started
2.1 Quick Start Guide
Monitor Station V2
Owner’s Manual
11
2. Connect the inputs of the headphone amplier to the Monitor Station V2’s Cue L/R
Line Outputs.
3. Calibrate the device’s audio levels according to its user
manual or visit its manufacturer’s Web site for information
about the recommended calibration process.
Note: If the headphone amplier doesn’t have a recommended calibration process,
increase the Monitor Station V2’s Cue Output knob to Unity Gain by turning
it fully clockwise and then adjust the amplier’s input level as necessary.
2.1.9 Connect the Main Outputs
The Main L/R Line Outputs provide what’s essentially a “thru” circuit for the Monitor
Station V2’s input sources. They’re typically used to feed external devices that
need a constant full-strength input signal, such as tape machines or digital stereo
recorders. The audio they carry is determined by the Main Source (described in
Section 3.1.4), and their output level is equal to the original input source level.
1. Turn the input and output levels of the external
device to be connected all the way down.
2. Connect the inputs of the external device to the Monitor Station V2’s Main L/R Line
Outputs.
3. Calibrate the device’s audio levels according to its user
manual or visit its manufacturer’s Web site for information
about the recommended calibration process.