Owners Manual
Table Of Contents
- 1 Overview
- 1.1 Introduction
- 1.2 Features
- 1.3 What’s in the Box
- 2 Getting Started
- 2.1 Quick Start Guide
- 2.1.1 Connecting the Monitor Station V2’s Power
- 2.1.2 Connecting Devices to the Monitor Station V2’s Inputs
- 2.1.3 Calibrating the Monitor Station V2’s LED Meter
- 2.1.4 Setting the Output Level of Your Audio Sources
- 2.1.5 Connecting Speakers to the Monitor Station V2
- 2.1.6 Calibrating Your Speaker Levels
- 2.1.7 Calibrate the Talkback Microphone
- 2.1.8 Connect the Cue Outputs
- 2.1.9 Connect the Main Outputs
- 2.2 Basic Hookup Diagram
- 2.3 Advanced Modes
- 2.3.1 Speaker Select Modes
- 2.3.2 Main and Cue Source Modes
- 2.3.3 Input LED Meter Modes
- 2.3.4 Reset All Modes to the Factory Default
- 3 Hookup
- 3.1 The Back Panel
- 3.1.1 Inputs
- 3.1.2 Speaker Outputs
- 3.1.3 Line Outputs
- 3.1.4 Power
- 4 Controls
- 4.1 The Front Panel
- 4.1.1 Talkback
- 4.1.2 Cue Control
- 4.1.3 Aux Control
- 4.1.4 Main Source Control
- 4.1.5 Speaker Control
- 4.1.6 Main Level Controls
- 5 Resources
- 5.1 Audio Specifications
- 5.2 Frequently Asked Questions
- 5.3 Troubleshooting
- 5.4 PreSonus Limited Warranty
3 Hookup
3.1 The Back Panel
Monitor Station V2
Owner’s Manual
15
Speaker B L/R Outputs: Connect your second powered-
speaker system to the balanced B L/R Speaker Outputs.
Speaker C L/R Outputs: Connect your third powered-speaker
system or subwoofer to the balanced C L/R Speaker Outputs.
Speaker Output Trim A, B, and C: These trims ne-tune the levels of the speaker
outputs. When possible, they should be set fully clockwise for Unity Gain.
3.1.3 Line Outputs
Main L/R Line Outputs: Monitor Station V2 passes input audio sources
directly to the Main L/R Line Outputs. These outputs derive their signal
directly from the currently selected Main input sources and are unaected
by the Main level-control knob and the Mono, Mute, and Dim buttons.
Connect these balanced ¼” TRS jacks to the inputs of a stereo device.
Cue L/R Line Outputs: The Cue L/R outputs derive their signal from the Cue Source
selection, and their level is controlled by the Cue Output knob. Connect the balanced
¼” TRS Cue L/R Line Outputs to a stereo headphone-distribution amplier.
3.1.4 Power
Power Input: Connect the supplied power-supply unit to
a grounded AC outlet and then to this input.
WARNING: Before connecting the Monitor Station V2’s included power
supply, make sure that the power supply meets the input-voltage
requirements of the region or country in which you’re using it. PreSonus supports
only the power supply shipped with your Monitor Station V2. If the power supply
doesn’t meet your local requirements—or if you wish to purchase an additional
power supply—please contact your local dealer or distributor.
Power Switch: To turn on the Monitor Station V2, press in the “|” at the top of
the Power switch. To turn it o, press the “0” at the bottom of the switch.