Owners Manual
Table Of Contents
- 1 Overview
- 1.1 Introduction
- 1.2 About This Manual
- 1.3 What’s in the Box
- 1.3.1 What Else You Need
- 1.4 Companion PreSonus Products
- 2 Getting Started
- 2.1 Direct connect with a StudioLive Series III mixer
- 2.2 Direct connect with a StudioLive Series III rack mixer
- 2.3 Using an NSB-series Stage Box with Two or More Mixers
- 3 Gain Compensation
- 3.1 Remote Preamp Control (Console Mixers)
- 3.2 Remote Preamp Control (UC Surface)
- 4 Hookup
- 4.1 Front-Panel Connections
- 4.2 Left-panel Connections
- 4.3 Right-panel Connections
- 5 Technical Information
- 5.1 Specifications
- 6 Warranty
- 6.1 Warranty Information
10
2 Getting Started
2.2 Direct connect with a StudioLive Series III rack mixer
NSB-Series Stageboxes
Owner’s Manual
Step 3: Engaged Network Sources
1. Click or tap on the Digital Patching tab.
2. By default, the Input Source tab will be active. Select AVB from the Source Type
selection.
3. Click or tap on the source icon for Channels 25-32 to change each channel’s
source input to AVB. This will enable the corresponding NSB stage box input to
each channel (e.g. NSB Input 1 will be enabled on StudioLive 24R channel 25,
NSB Input 2 will be enabled on StudioLive 24R channel 26, etc.)
Your NSB 8.8 is now ready to use!