Owners Manual
Table Of Contents
- 1 Overview
- 1.1 Introduction
- 1.2 About This Manual
- 1.3 What’s in the Box
- 1.3.1 What Else You Need
- 1.4 Companion PreSonus Products
- 2 Getting Started
- 2.1 Direct connect with a StudioLive Series III mixer
- 2.2 Direct connect with a StudioLive Series III rack mixer
- 2.3 Using an NSB-series Stage Box with Two or More Mixers
- 3 Gain Compensation
- 3.1 Remote Preamp Control (Console Mixers)
- 3.2 Remote Preamp Control (UC Surface)
- 4 Hookup
- 4.1 Front-Panel Connections
- 4.2 Left-panel Connections
- 4.3 Right-panel Connections
- 5 Technical Information
- 5.1 Specifications
- 6 Warranty
- 6.1 Warranty Information
17
2 Getting Started
2.3 Using an NSB-series Stage Box with Two or More Mixers
NSB-Series Stageboxes
Owner’s Manual
Step 7: Routing Inputs to your rack mixer
In our example, we are using the NSB 8.8 to also add 8 more inputs to the StudioLive
24R create a full 32-channel mixer. Let’s open up UC Surface and get that routed!
1. In UC Surface connected to your StudioLive 24R, press the Settings gear.
2. Click on the Network Tab.
3. From the Stagebox Setup area, click on the AVB Inputs tab.
4. Click or tap on the drop-down menu for Input 25-32 and select NSB 8.8: Send
1-8 (GC). These are the gain compensated streams for your NSB 8.8. Please see
Section 3 for more information on Gain Compensation.
In our example, we will also be using routing inputs 1-8 on the StudioLive
32SX as part of our monitor mix. Let’s go ahead and route those now.
5. Click or tap on the drop-down menu for Input 1-8 and select StudioLive 32SX:
Send 1-8