Owners Manual
Table Of Contents
- 1 Overview
- 1.1 Introduction
- 1.2 About This Manual
- 1.3 What’s in the Box
- 1.3.1 What Else You Need
- 1.4 Companion PreSonus Products
- 2 Getting Started
- 2.1 Direct connect with a StudioLive Series III mixer
- 2.2 Direct connect with a StudioLive Series III rack mixer
- 2.3 Using an NSB-series Stage Box with Two or More Mixers
- 3 Gain Compensation
- 3.1 Remote Preamp Control (Console Mixers)
- 3.2 Remote Preamp Control (UC Surface)
- 4 Hookup
- 4.1 Front-Panel Connections
- 4.2 Left-panel Connections
- 4.3 Right-panel Connections
- 5 Technical Information
- 5.1 Specifications
- 6 Warranty
- 6.1 Warranty Information
20
3 Gain Compensation
3.2 Remote Preamp Control (UC Surface)
NSB-Series Stageboxes
Owner’s Manual
After you have set the preamp levels, enable Gain Compensation from the LCD. This
will turn on Gain Compensation for that input and allow other mixers on the network
to source that stream.
Note: If you do not enable Gain Compensation, making a change on the mixer with
preamp control over the NSB stage box will change it for any device listening to that
stream on the network.
3.2 Remote Preamp Control (UC Surface)
After you route the NSB inputs to your console mixer, select
Network for the source on the corresponding channels.
Select the channel for which you’d like to set the gain.
You can now control the preamp level and phantom power for your NSB stage box
from the Fat Channel in UC Surface, in the same way that you control the local inputs.
Gate
FX C FX D
FX A FX B
EFFECTS MASTER MASTER CONTROL
-2
-12
-24
-36
-4
8
-65
Ch. 1
48V
EQ
Gate0 dB
PreAmp
Input Del.HPF
44 Hz 2.5 ms
Comp Limiter
A
PreampGa.. 0db
1/2
3
4
5
6
7
8
A
B