User Manual

15
4 UC Surface Control Software
4.3 Main Knob Controls
Quantum-series
Owner’s Manual
4.3 Main Knob Controls
The large Main level encoder can be used to control any or every output
on your Quantum-series interface. Use these controls to select which
output levels are adjusted with this knob. It should be noted that this knob
always controls the Main Left/Right outputs on Quantum and Outputs
1/2 on Quantum 2. Other analog outputs pairs can be added.
Power User Tip: The volume of any output pair will jump to 0 dB when it is unassigned
from the Main Knob. Because of this, make sure to manage your output volume in your
DAW before disengaging this option.
4.4 Main Output Controls
These controls mimic the front panel options on the Quantum,
allowing you to remote control the Main Output Mute, Dim and
Mono options. These control are not available for Quantum 2.
From here, you can also choose to have your S/PDIF outputs mirror the Main outputs.
4.5 Talkback (Quantum)
The Talkback feature lets you communicate with the performers. Talkback
routing is handled directly to your DAW, simply create a track and assign
its input to the Talkback and route the track to the desired outputs.
Click on the Talkback button to enable the Talk function on your Quantum.
You can then turn on the Talkback mic in any of the mixes from your DAW.
The level of the Talkback mic can also be remote controlled from Studio
One, UC Surface, or by selecting the “c” (Comm) channel in the preamp
control section and use the encoder to adjust the level(Quantum only).
Note: Talkback must be routed to the output pair from your DAW and have its Talkback
level above zero for it to heard through that output. If either has not been done, talkback
cannot be heard in that output.