User Manual

11
R65 and R80 Owner’s Manual
3.6 Energy Conservation Mode
Your R65/R80 features an Energy Conservation mode.
When Energy Conservation mode is active, the onboard
amplifier will enter low-power mode after thirty minutes
of inactivity. Once signal is detected again, the amplifier
will take three seconds to return to full power.
By default, this mode is disabled but can be enabled
by pressing and holding the Acoustic Space and HF
Driver buttons simultaneously for 3 seconds. The
mode can be disabled by repeating this procedure.
When Energy Conservation mode is active, all four HF Driver
LEDs will illuminate green.
When Energy Conservation mode is disabled, all four
Acoustic Space LEDs will illuminate red.
The Energy Conservation mode status can be
querried by simply pressing the Acoustic Space
and HF Driver buttons simultaneously.
Power User Tip: Because querying or changing Energy
Conservation Mode may inadvertently change your
Acoustic Space or HF Driver setting, it is recommended
that you double-check these settings afterwards.
Acousc
Space
HF Driver
HP Filter
-1.5dB
-3dB
-6dB
Linear
+1dB
-1.5dB
-4dB
Linear
60Hz
80Hz
100Hz
Linear
ACOUSTIC TUNING
Press
and hold
Press
and hold
Acousc
Space
HF Driver
HP Filter
-1.5dB
-3dB
-6dB
Linear
+1dB
-1.5dB
-4dB
Linear
60Hz
80Hz
100Hz
Linear
ACOUSTIC TUNING
(Green)(Green)(Red)(Red)
Acousc
Space
HF Driver
HP Filter
-1.5dB
-3dB
-6dB
Linear
+1dB
-1.5dB
-4dB
Linear
60Hz
80Hz
100Hz
Linear
ACOUSTIC TUNING
(Green)(Green)(Red)(Red)