User Manual

2 Hookup

2.1 Rear Panel Connections and Controls

Sceptre

™

S6 and S8

Owner’s Manual

Power Switch: This is the On/Oﬀ switch. The power status is

indicated by an LED on the front of the cabinet.

Note: The input-power voltage is set internally at the factory to

correspond with the country to which your Sceptre monitor was

shipped. Do not use your Sceptre monitor in a country that uses a

diﬀerent standard voltage than is used in the country where you

purchased your Sceptre S6 or S8.

2.1.3 Acoustic Tuning Controls

Acoustic Space: Cuts the level of all frequencies below 250 Hz

by the speciﬁed amount (-1.5, -3, or -6 dB) to compensate for

the bass boost that occurs when the monitor is placed near a

wall or corner. Can be defeated by setting it to Linear.

Repeatedly pushing the corresponding button cycles through

the available settings.

HF Driver: Boosts or cuts all frequencies above 2 kHz by the

speciﬁed amount (+1, -1.5, or -4 dB). Can be defeated by

setting it to Linear. Repeatedly pushing the corresponding

button cycles through the available settings.

HP Filter: Rolls oﬀ the level of all frequencies below the

speciﬁed frequency (60, 80, or 100 Hz), with a slope of -24 dB/

octave. Can be defeated by setting it to Linear, in which case,

the monitor’s natural rolloﬀ takes over (42 Hz for S6,

38 Hz for S8). Repeatedly pushing the corresponding button

cycles through the available settings.