User Manual

57
6 Digital Effects | Master Control
6.5 Using MIDI Control Mode to Remote-Control StudioLive
StudioLive™ 16.0.2 USB
Owner’s Manual
You’re almost done! Now you need to set the global MIDI channel on
which your FCB1010 will control FXA and FXB output levels, assign/
unassign FX to Mains, and control the Main output level.
1. Press Pedal 6 so that its red LED is flashing.
2. Press the Up pedal to select the MIDI channel for Pedal 6.
3. In our example, the global MIDI functions are set to MIDI Channel 4. But you
can assign global MIDI functions to the same channel as any of the recall
functions, if you prefer. Press Pedal 4 so that the LED readout displays “4.”
4. Press the Up pedal twice to confirm the change and cycle back to MIDI Function
5. Repeat steps 1-3 for Pedals 7-9.
6. Press and hold the Down pedal to exit Global Configuration mode.
Making Presets on an FCB1010
In our example, we will create one preset for Scene recall, one for FXA assign/
unassign to Mains, and one for Main volume control. You can also use these
instructions to create presets for the remaining controllable parameters. We
will create a StudioLive bank of presets on Bank 00. If you have presets already
saved to this bank, you can use any of the other nine banks instead.
Scene Recall
1. Select Bank 00 by using the Up or Down pedals.
2. Press Pedal 1 to select Preset 1.
3. Press and hold the Down pedal to enter Preset Configuration
mode. (You’ll see a flashing green LED.)
4. Press the Up pedal to confirm.
5. Press Pedal 1 so that the red LED is flashing.
6. Press the Up pedal to make the Program Change assignment.
7. Select Scene 02 using Pedal 2 or Expression Pedal A.
8. Press the Up pedal to confirm.
9. Press and hold the Down pedal to exit.
FXA Preset Recall
1. To set up pedal control of FXA preset changes, press Pedal 3 so that Preset
3 is selected on your FCB1010. Make sure that Bank 00 is still selected.
2. Repeat Scene Recall steps 3-9, using Expression Pedal A to select FX preset 20.
FXA Assign/Unassign to Main Bus and Main Output Level Control
Let’s create a preset to assign/unassign FXA to the Main bus and to control
the Main output volume using an expression pedal on the FCB1010.
1. First press Pedal 6 to select Preset 6, making sure that Bank 00 is still selected.
2. Press and hold the Down pedal to enter Preset Configuration
mode. (You’ll see a flashing green LED.)
3. Press the Up pedal to confirm.
4. Press Pedal 6 so that the red LED is flashing.