User Manual

13
4 UC Surface Monitor Control Software
4.1 UC Surface Launch Window
Studio 192
Owner’s Manual
4.1 UC Surface Launch Window
Sample Rate. Changes the sample rate.
You can set the sample rate to 44.1, 48, 88.2, or 96 kHz. A higher sample
rate will increase the fidelity of the recording but will increase the file size
and the amount of system resources necessary to process the audio.
At 44.1 and 48 kHz, all DSP functions are available. At 88.2, 96,
176.4, and 96 kHz, Fat Channel processing will be available on
analog inputs only and the delay bus will be disabled.
Clock Source. Sets the digital clock source.
From this menu, you can set the clock source for your Studio
192: Internal, External S/PDIF, or External ADAT.
Please note: Only ADAT 1 can be used as a clock source input for your Studio 192.
Block Size. Sets the buffer size.
From this menu, you can set the buffer size for your Studio 192 from 16 to 4,096
samples. Lowering the buffer size will lower latency; however, this will also
increase performance demands on your computer. In general, you will want
to set the buffer size as low as your system can safely support. If you begin to
hear pops, clicks, or distortion in your audio path, try raising the buffer size.