User Manual

26
4 UC Surface Monitor Control Software
4.6 Quick Controls: Talkback, Scenes, and More
Studio 192
Owner’s Manual
4.6 Quick Controls: Talkback, Scenes, and More
The Quick Controls panel provides access to the following controls:
• Talkback routing, on/off
• Scene management
• Quick Scenes
• Mute Groups
• FXA and FXB Mute
• FXB Tap tempo
• Headphone Mix Select
• S/PDIF Source Select
You will find the Show/Hide button for the Quick Controls panel at the far right of the
mixer. Clicking or tapping on it will open or close the panel.
4.6.1 Talkback
The Talkback feature lets you communicate with the performers.
The talkback level is individually controllable from each mix. You will
find the level control after the input and playback channels.
Click on the Talkback button to enable the Talk function on your Studio 192.
You can then turn on the Talkback mic in any of the mixes by clicking or tapping
on the mix select. By default, the talkback source is the onboard mic on your
Studio 192. This can be changed from the Settings page. See Section 4.5.
The Mix Select buttons for the mixes that have Talkback routed
to them will turn red to indicate that Talkback is active.
You can also click on the Talk Assign button to assign Talkback
routing without the Talkback mic enabled.
The level of the Talkback mic is controlled from the front panel
of your Studio 192. Select the “c” (Comm) channel in the preamp
control section and use the encoder to adjust the level
Note: Talkback must be enabled for the mix and have its Talkback fader level
above zero in that mix for it to heard through that output. If either has not been
done, talkback cannot be heard in that mix. Talkback can be routed independently
to the headphone outputs and their corresponding mirrored mix outputs.