User manual

Table Of Contents
6
2 Connecting to a Computer
2.2 Installation for macOS
StudioLive™ Software
Library Reference Manual
2.2 Installation for macOS
The UC Surface installer will take you through each step of the
installation process. Please read each message carefully, and be especially
careful that you do not connect your StudioLive too soon.
1. After launching the installer, you will be directed to the Welcome screen.
Click “Continue and follow the onscreen instructions.
2. You will be asked which installation type you would like to perform. You do
not need to install the StudioLive AI-series FireWire Driver.
3. When the installation is completed, you will be prompted to reboot your
computer. After your Mac has restarted, connect your StudioLive with the
appropriate transport cable and power it on.
4. Once the installation is completed, you will find the UC Surface program in
your Applications folder. It is recommended that you place this in your Dock.
You are now ready to use your StudioLive with your computer!
2.3 Using the StudioLive as an Audio Interface
The StudioLive mixers feature a built-in audio interface that can be
used with any application that supports Core Audio or ASIO and
can also be used as a WDM device for a Windows computer.
Every input plus the Main mix can be recorded. Please review Section 2.5 of this
manual for more information on using audio streams are for recording and playback.
Power User Tip: If your StudioLive will not connect to the computer, verify that the
USB cable is properly connected to the StudioLive and to your computer and disconnect
all unnecessary peripheral devices on the same transport bus.