User manual

Table Of Contents
11
3 Networking Your Remote Devices
3.1 Connecting your Computer to your Network
StudioLive™ Software
Library Reference Manual
3 Networking Your Remote Devices
In order to use your mobile devices to remote control your StudioLive 16.0.2
USB mixer, you must first connect it to a Mac or Windows computer via
USB with Universal Control installed and running. The computer running
Universal Control must then be connected to the same network as your
mobile devices. This section will cover networking proceedures.
Power User Tip: Network connections occasionally require troubleshooting, especially
when a lot of wireless networks are in use. Because of this, it is always a good idea to get
your networked devices and StudioLive happily communicating before the pressure is on,
and you have a singer trying to dial in a monitor mix while you’re trying to mic the drum
kit. So while the guitarist is flirting with the bartender, take a quick moment to get your
iPad, iPhone, computer, and StudioLive talking.
3.1 Connecting your Computer to your Network
Windows 7+
1. Click on the network icon in the notification area to
open the Connect to Network Control Panel.
2. Select the wireless network you’d like to use.
3. Enter the password.
4. Click Connect.
macOS 10.8 and later
1. On the Menu bar click on the Wireless Status icon.
2. From the pull-down menu select the wireless network you’d like to use.
3. Enter the password.
4. Click Join.
Router
Laptop running
UC Surface
Android phone
running QMix-UC
iPad running
UC Surface