StudioLive™ Series III Stagebox Mode Addendum ® www.presonus.
Table of Contents 1 Overview — 1 1.1 About AVB Networking — 1 2 Getting Started — 2 2.1 Channel Routing Grid — 5 2.2 Preamp Control — 6 2.3 Stagebox Modes — 6 2.
1 1.1 1 Overview About AVB Networking StudioLive™ Series III Stagebox Mode Addendum Overview There are two types of potential data flowing to and from your StudioLive Series III mixer: control and audio. Control connections can be made over standard Ethernet networks, including WiFi networks. Sending and receiving audio requires an AVB network. Unlike control, AVB audio cannot be sent wirelessly.
2 1.1 2 StudioLive™ Series III Stagebox Mode Addendum Getting Started About AVB Networking Getting Started StudioLive Series III rackmount mixers can be used as digital stageboxes for any StudioLive Series III console mixer. This guide will get you up and running. Important: Both StudioLive Series III mixers must be updated with the latest firmware before configuring stagebox mode. Firmware updates and instructions are available from within your My PreSonus user account.
2 1.
2 1.1 Getting Started About AVB Networking StudioLive™ Series III Stagebox Mode Addendum 3. Press the Stagebox Setup button on the screen. FX A FX B FX C FX D EFFECTS MASTER MASTER CONTROL 4. Tap on the “Select Rack Mixer” menu and choose your rack mixer from the list. If you have more than one rack mixer connected on the network and are unsure which mixer is which, you can press the Identify button.
2 2.1 Getting Started Channel Routing Grid StudioLive™ Series III Stagebox Mode Addendum 8. Tap Apply to save the mode. Power User Tip: Connecting to your mixer and selecting the mode can be one or two steps. When Apply is pressed, both the selected mixer and the selected Stagebox Mode are saved simultaneously. FX A FX B FX C FX D 2.1 Monitor Channel Routing Grid StudioLive Series III mixers route channels in banks of 8.
2 2.2 StudioLive™ Series III Stagebox Mode Addendum Getting Started Preamp Control Preamp Control 2.2 PREAMP Gain 0 dB HI PASS Filter off PAN Center Once the Network input has been selected on the StudioLive Series III console mixer, you can remote control the preamp level and phantom power for your rackmount mixer from the top panel of your console mixer. Note: When “Off” is selected for Stagebox mode, preamp and phantom power control will not be active.
2 2.3 Getting Started Stagebox Modes StudioLive™ Series III Stagebox Mode Addendum Monitor Mix While this mode is active, the StudioLive Series III rackmount mixer retains all its mixing functionality for every FlexMix, allowing you to create monitor mixes and more using the FlexMix outputs. The Main Mix in this mode will not be accessible or have any effect on the sound as this mix is sourced from the Main Left/Right mix of the console mixer and must be controlled from there.
2 2.4 2.4 StudioLive™ Series III Stagebox Mode Addendum Getting Started Recording in Stagebox Mode Recording in Stagebox Mode When any Stagebox Mode is active, recording is only supported from the console mixer (USB or SD). Because of this, you will want to configure the channels on your StudioLive Series III console mixer for your recording.
For every channel that you want to source from the Network and record from the console mixer (either USB or SD), you need to set the Digital Send Source to “Digital”. To do this, navigate to the channel settings on the console mixer and enable the Digital Send Source.
StudioLive™ Series III Stagebox Mode Addendum ® 18011 Grand Bay Ct. • Baton Rouge, Louisiana 70809 USA• 1-225-216-7887 www.presonus.
