User Manual

5
2 Getting Started
2.1 Channel Routing Grid
StudioLive™ Series III
Stagebox Mode Addendum
8. Tap Apply to save the mode.
Power User Tip: Connecting to your mixer and selecting the mode can be one or two
steps. When Apply is pressed, both the selected mixer and the selected Stagebox Mode are
saved simultaneously.
2.1 Channel Routing Grid
StudioLive Series III mixers route channels in banks of 8. From the Channel Routing
page, you can change the default routing:
Note: Once channels have been patched between your StudioLive Series III rackmount
mixer to your StudioLive Series III console mixer, they can be accessed by selecting the
Network input as the source on either mixer. For example, if you would like Channel 1 on
your console mixer to be sourced from Channel 1 on your rack mixer, you must select
Network as the input source on your console mixer. In this way, you can access local
analog, network, USB, or SD input sources for each channel as needed.
Select Network on Console
If you would like the input source for any channel on your StudioLive Series III
console mixer to come from your StudioLive Series III rack mixer, select that channel
on your console mixer and enable Network as the Input Source. For example, if you
would like to use the guitar connected to Input 3 on your StudioLive 16R in any mix
on your StudioLive 24, you would select Channel 3 on your StudioLive 24 and enable
Network as the input source.
Select Network in UC Surface
If you would like the input source for any channel on your StudioLive Series III rack
mixer to come from your StudioLive Series III console mixer, select that channel
on your rack mixer in UC Surface and enable Network as the Input Source. For
example, if you would like to use the microphone connected to Input 30 on your
StudioLive 32 in any mix on your StudioLive 32R, you would select Channel 30 in
UC Surface for your StudioLive 32R and enable Network as the input source.
MonitorFX C FX D
FX A FX B
MonitorFX D
FX B
EFFECTS MASTER MASTER CONTROL