Owner's manual

68
5 Digital Effects | Master Control
5.2 Scenes
StudioLive™ 24.4.2/16.4.2
Owner’s Manual
EQ and Dyn: All Fat Channel dynamics processing, filter
parameters, and pan position for every channel and bus.
Aux Mix: All aux mixes parameters including:
• Channel sends to aux mixes
• Channel sends to FXA and FXB
• Pre1/Pre2 position for each aux and FX bus
Faders: All fader positions.
GEQ: Graphic EQ settings for all eight graphic equalizers.
Pots: All digital knob positions:
• Aux output levels
• FXA and FXB levels
• Cue level
• 2 Track In
• Phones level
• Monitor level
• Talkback level (level, not trim control)
• Aux Input A and Aux Input B level
Power User Tip: If you enable knob positions (recalling group “pots”) as a part of your
Scene recall, all of the digital knobs (Aux outputs, FXA and FXB levels, Cue, 2 Track In,
Phones, Monitor, Talkback, Aux Input A and Aux Input B knobs) will remain at their
stored position until they are moved manually. Once a knob is turned, its value will
jump to the value of its current physical position. Therefore, if you intend to save a Scene
and recall the “pots” group later, it is highly recommended that you use the recall sheet
provided in the back of this manual to note the stored position of these controls.
It is important to note that the recall groups have no effect on what
parameters are stored with a Scene. All storable parameters are saved
with a Scene regardless of what recall groups are enabled.
Note: The following StudioLive global parameters are not recallable:
• Input Trim controls
• Output Trim controls
• Subgroup Delay settings
• LCD Contrast
• LCD Brightness
• Link ID
• Sample Rate
• GEQ bus assignments (StudioLive 24.4.2 only)