User Manual

36
5 The Fat Channel
5.1 Fat Channel Navigation
StudioLive™ Series III
Owner’s Manual
12. Delay. Sets the amount of alignment delay applied to the input channel or bus.
Touch to enable manipulation by the Master Control encoder. See Section 11.6
and 11.7 for more information.
13. HPF Frequency. Sets the High Pass Filter cut-off frequency. Touch to enable
manipulation by the Master Control encoder.
14. Pan. Sets the pan position. Touch to enable manipulation by the Master Control
encoder.
15. Preamp Gain. Sets the preamp gain. Touch this knob to enable manipulation by
the Master Control encoder.
16. +48v. Touch to enable/disable phantom power.
17. Polarity Invert. Touch to enable/disable polarity invert.
5.1.1.1 Channel Settings Screen
When the overview screen for a channel or bus is open, you can the Channel Settings
screen by tapping on the Settings button (Call-out #5).
5
4
1
2
3
1. Channel Name. Touch the name field to enter a new name with the onscreen
keyboard.
2. Channel Type. Touch the type field to choose between the standard identifying
channel types (such as Guitars or Drums).
3. Digital Send Options. Touch Pre (signal is sent before Fat Channel processing)
or Post (signal is sent after Fat Channel Processing) to choose the signal routing
when sending this channel or bus to a USB or network-connected audio device.
4. Channel Color. Sets the color of a channel’s Select button. If no color is selected,
the Select button will be blue.
5. Stereo Link Options. These options let you specify the linking behavior when
you link pairs of channels or buses, with the following options:
- Preamp Level/Trim. Enable this option to link preamp level and trim
settings when channels are linked. Disable to allow these settings to be
individually set for each linked channel.
- Panning. Enable this option for “stereo” panning mode, which lets you
use the pan controls on linked channels or buses to control overall stereo
“width.” Moving a pan control on a linked channel moves the corresponding
pan control the same amount in the opposite direction. Disable this option
to allow independent panning of linked channels or buses.
- Fader Levels. Enable this option to link volume faders for linked pairs of
channels or buses. Disable it to allow independent manipulation of fader
levels for linked channels.