User Manual

48
5 The Fat Channel
5.1 Fat Channel Navigation
StudioLive™ Series III
Owner’s Manual
5.1.4.2 Passive Program EQ
When the Passive EQ is selected, the following controls are available in the
Fat Channel:
HIGH
HIGHHIGHLOWLOWLOW
Boost Atten Freq Boost Bndwdth Freq Atten Select
HIGH ATTN
0.00 10 kHz5 kHz0.060.0230 Hz0.000.00
1 2 3 4 5 6 7 8
1. Low Boost. Sets the level of boost applied around the chosen low frequency.
This control interacts nicely with the Low Attenuation control, allowing for
boosts in apparent bass energy while keeping overall bass energy within
optimal limits.
2. Low Attenuation. Sets the level of attenuation applied around the chosen low
frequency. This control interacts nicely with the Low Boost control, allowing
for boosts in apparent bass energy while keeping overall bass energy within
optimal limits.
3. Low Frequency Select. Sets the center frequency of the band covered by the
Low Boost and Low Attenuation controls.
4. High Boost. Sets the level of boost applied around the chosen high frequency.
5. High Bandwidth. Sets the Q (or width) of the effect of the high EQ band.
6. High Frequency. Sets the center frequency of the high EQ band.
7. High Attenuation. Sets the amount of attenuation applied in a shelving fashion
to frequencies at and above the chosen high frequency.
8. Attenuation Select. Sets the frequency at and above which the High
Attenuation control attenuates treble content.
Press the Processor button to turn the EQ on or off.
When the Fat Channel is in Passive EQ mode, the touchscreen shows an overview
screen, displaying the relevant parameters (as available in the Fat Channel).
Touching any onscreen knob allows you to use the Master Control encoder to set the
selected parameter.
2
1
4
3
6
8 9
5 7
1. EQ On/Off. Enables/disables the EQ globally. Touch to toggle on or off
2. Low Boost. Boosts the Low Band.
3. Low Frequency. Sets the center frequency for the Low Band.
4. Low Attenuation. Attenuates the Low Band.
5. High Bandwidth. Sets the bandwidth (Q) for the High Band.
6. High Boost. Boosts the High Band.
7. High Frequency. Sets the center frequency for the High Band.
8. High Attenuation. Sets the attenuation for the High Band.
9. Attenuation Select. Sets the Frequency at which the attenuation begins.