User Manual

76
8 Master Control
8.5 Scenes
StudioLive™ Series III
Owner’s Manual
8.5 Scenes
The StudioLive allows you to create and store a library of scenes. A scene is like a
snapshot of your mix. It stores each Fat Channel parameter for every input and bus,
as well as each fader’s position, the aux and effects mixes, channel mutes and solos,
and the input selection (analog input or digital playback stream).
To begin working with scenes, press the Scenes button. This brings the Scenes screen
onto the touchscreen. On this screen, a list of all existing scenes is shown.
8.5.1 S1: Zero Out (Board Reset)
Located at position S1 is a scene named Zero Out (Board Reset). This scene cannot
be overwritten and returns each parameter to its default setting. All you have to
do is lower all the Monitor bus output volume knobs to their lowest positions. The
StudioLive will be zeroed out as follows:
Inputs and
Buses
Output
Level
Assign Pan Solo Mute
Stereo
Link
Aux/FX
Sends
Mode
Input Chan-
nels
-∞ Mains C Off Off Off -∞ n/a
Flex Buses -∞ n/a n/a Off N/a Off n/a Aux: Pre 1
FXA Unity Mains n/a n/a Off n/a n/a
Standard
Reverb: Post
FXB Unity Mains n/a n/a Off n/a n/a
Standard
Reverb: Post
FXC Unity Mains n/a n/a Off n/a n/a
Mono Delay:
Post
FXD Unity Mains n/a n/a Off n/a n/a
Mono Delay:
Post
Aux In A/B -∞ Mains n/a n/a n/a n/a -∞ n/a
Solo Bus -∞ n/a n/a n/a n/a n/a n/a AFL
Monitor Bus -∞ n/a n/a n/a n/a n/a n/a Main
Tape In -∞ n/a n/a n/a n/a n/a -∞ -∞