User Manual

77
8 Master Control
8.5 Scenes
StudioLive™ Series III
Owner’s Manual
The Fat Channel will be restored to the same setting for every input and output
on the StudioLive. Each of the dynamics processors and the four EQ bands will be
turned off.
Their parameters will be set as follows:
Fat Channel Parameters
CHANNEL HIPASS NOISE GATE LIMIT COMPRESSOR EQ LOW L.MID H.MID HIGH
GAIN 0db OFF STATE OFF STATE OFF THRESH 0 dB STATE OFF OFF OFF OFF
PAN <C> RANGE N/A RAT 2:1 P/S PEAK n/a n/a PEAK
Source Analog ATK 5 ms ATK 20 ms Q 0.6 0.6 0.6 0.6
REL 0.7 ms REL 150 ms FREQ 130 Hz 320 Hz 1.4 kHz 5 kHz
Key Src Off GAIN 0 dB GAIN 0 dB 0 dB 0 dB 0 dB
Key Fltr Off MODE Standard MODE Standard
Mode Expand
Power User Tip: Before beginning any new mixing situation, we recommended you recall
the Zero Out (Board Reset) scene. This is the easiest way to ensure that there are no
lingering parameter settings that could cause you some trouble in your new mix.
8.5.2 Nulling Parameters
To return any Fat Channel parameter to its Zero Out scene setting, simply press
and hold the Tap Tempo button and turn its encoder.
For example, if you want to null the current setting for the Channel 1 pan:
1. Select Channel 1.