Manual
67
5 Digital Effects | Master Control
5.3 Scenes
StudioLive™ AI-series Mixers
Owner’s Manual
5.3 Scenes
The StudioLive allows you to create and store a library of scenes. A scene is like a
snapshot of your mix. It stores each Fat Channel parameter for every input and
bus, as well as each fader’s position, the aux and effects mixes, channel mutes
and solos, and the input selection (analog input or digital playback stream).
5.3.1 S1: Zero Out (Board Reset)
Located at position S1 is a scene named Zero Out (Board Reset). This scene cannot
be overwritten and returns each parameter to its default setting. All you have
to do is lower the faders and return all trim knobs and output volume knobs
(Solo bus, 2 Track In, Aux Input A and B, Aux Outputs, FX Outputs, Phones, and
Monitor) to their lowest positions. The StudioLive will be zeroed out as follows:
SETTINGS
INPUTS AND BUSES OUTPUT LEVEL ASSIGN PAN SOLO MUTE STEREO LINK AUX/FX SENDS MODE
INPUT CHANNELS
NULL MAINS C OFF OFF OFF NULL N/A
AUX BUSES
NULL N/A N/A OFF N/A OFF N/A PRE 1
FX BUSES
NULL MAINS N/A N/A OFF N/A N/A POST/R1/D1
AUX IN A/B
NULL MAINS N/A N/A N/A N/A NULL N/A
SOLO BUS
NULL N/A N/A N/A N/A N/A N/A AFL
MONITOR BUS
NULL N/A N/A N/A N/A N/A N/A MAIN
TAPE IN
NULL N/A N/A N/A N/A N/A NULL NULL
Each GEQ will be flattened and returned to its default Off state. The Fat Channel
will be restored to the same setting for every input and output on the StudioLive.
Each of the dynamics processors and the four EQ bands will be turned off.
Their parameters will be set as follows:
STUDIOLIVE 32.4.2AI AND 24.4.2AI FAT CHANNEL PARAMETERS
HIPASS NOISE GATE LIMITER COMPRESSOR EQ LOW L.MID H.MID HIGH
OFF KEY N/A OFF THR 0 dB P/S PEAK N/A N/A PEAK
THR 0.05 s THR 0 dB RAT 2:1 Q 0.6 0.6 0.6 0.6
RNG N/A ATK 20 ms FREQ 130 Hz 320 Hz 1.4 kHz 5 kHz
ATK 5 ms REL 150 ms GAIN 0 dB 0 dB 0 dB 0 dB
REL 0.7 ms GAIN 0 dB
KNEE hard
STUDIOLIVE 16.4.2AI FAT CHANNEL PARAMETERS
HIPASS NOISE GATE LIMITER COMPRESSOR EQ LOW L.MID H.MID HIGH
OFF THR 0.05 s OFF THR 0 dB P/S PEAK N/A N/A PEAK
REL 0.7 ms RAT 2:1 Q 0.55 0.55 0.55 0.55
ATK 20 ms FREQ 130 Hz 320 Hz 1.4 kHz 5 kHz
REL 150 ms GAIN 0 dB 0 dB 0 dB 0 dB
GAIN 0 dB
Power User Tip: Before beginning any new mixing situation, we recommend you
recall the Zero Out (Board Reset) scene. This is the easiest way to ensure that there are
no lingering parameter settings that could cause you some trouble in your new mix.