User Manual

2 Hookup
2.1 What is in the Box
Temblor T8
Owner’s Manual
2
2 Hookup
2.1 What is in the Box
In addition to this manual, your Temblor T8 package contains the following:
• (1) PreSonus Temblor T8 powered subwoofer
• (1) IEC power cable
• (1) 2M ¼” TRS to TRS cable
2.2 Rear-Panel Connections and Controls
2.1.1 Inputs
Line-level Inputs: The Temblor T8 provides a choice of two input pairs: a pair
of balanced ¼” TRS inputs and one pair of RCA unbalanced inputs. When both
connections are in use, the RCA inputs will sum into the TRS connections.
Power User Tip: Connect both the left and right inputs if you are connecting your full-
range monitors to the T8’s outputs, or if you’re running your Temblor T8 independently
from a stereo source (such as the PreSonus Monitor Station). This will ensure that your
Temblor T8 receives the low-frequency content from both the left and right sides of a
stereo audio signal. If your audio source provides a mono or LFE output, you only need to
connect one input—either L or R.
Input Gain: Sets the level of the input signal before it is amplified.
2.1.2 Outputs
Outputs: The Temblor T8 provides two pairs of outputs: a pair of balanced
¼” TRS outputs and a pair of RCA unbalanced outputs. The full-range signal
connected to the stereo inputs on the T8 is passed through to these outputs.
Use these outputs to connect your main left and right studio monitors.
If the High Pass Filter switch is engaged, frequencies below 80 Hz are not sent from
these outputs.
Sleeve:
Ground
Ring:
[-]
Tip:
[+]
12
3
Ground
XLR TRS
[-]
[+]