User Manual

2 Getting Started
2.1 Level Setting Procedure (Full-Range)
ULT-series
Owner’s Manual
6
6. Power on your ULT-series loudspeaker.
7. While speaking into the microphone, use the Mic level knob to
adjust the microphone level. Be sure that you are not standing
directly in front of the loudspeaker while doing this, as doing so
could result in feedback. If you are not using the Mic input, it is
recommended that you leave this knob in the fully counter-clockwise
position so as not to introduce noise into your signal path.
8. With audio playing through your line-level source, turn the
Line level knob until you have achieved a comfortable listening
volume. If you are not using the Line input, it is recommended
that you leave this knob in the fully counterclockwise position
so as not to introduce noise into your signal path.
9. Both the Microphone and Line inputs should be set so that the
green Signal LED is illuminated most of the time, but the red Clip
LED illuminates only with the highest transient peaks or not at all.
10. If you are using the input mixer of one loudspeaker to
connect a microphone and a line-level source, or if you
are running a mono system, connect the Mix Out from the
loudspeaker to which your sources are connected to the line
input of the second loudspeaker and repeat steps 1-9.
POWER
On/O
100-230V~, 50-60 Hz, 150W
DIRECT OUT
MIX OUT
LINE
HPF DJ FOHMON SIGNAL CLIP TEMP
MIC/LINE
LINE LEVEL
MIC / LINE
-15 +65
M
I
C
L
I
N
E
LINE LEVEL
SIGNAL CLIP TEMP
SIGNAL CLIP TEMP
DIRECT OUT
MIX OUT
LINE
HPF DJ FOHMON SIGNAL CLIP TEMP
MIC/LINE
LINE LEVEL
MIC / LINE
MIC/LINE
-15 +65
M
I
C
L
I
N
E
DIRECT OUT
MIX OUT
LINE
HPF DJ FOHMON SIGNAL CLIP TEMP
MIC/LINE
LINE LEVEL
MIC / LINE
MIC/LINE
-15 +65
M
I
C
L
I
N
E