User Manual

2 Getting Started
2.2 Level Setting Procedure (ULT18)
ULT-series
Owner’s Manual
9
9. Turn the line level knob on your full-range
loudspeakers to the 12 o’clock position.
10. Turn the Output level knob on your ULT18 to the 12 o’clock position.
11. With audio playing through your line-level source, turn
the line level knob on your full-range loudspeakers until
you have achieved a comfortable listening volume.
12. The line-level inputs should be set so that the green Signal LED is
illuminated most of the time, but the red Clip LED illuminates only with
the highest transient peaks or not at all. If your line-level source is clipping
the inputs on your ULT18, you will need to turn down the source’s
output level.
If more high-frequency output level is required, turn the line-level knob
clockwise on your full-range loudspeakers. In most cases, the level should
be set the same on both loudspeakers.
Adjust the Output level control on your ULT18 to
balance the low-frequency content level to taste.
DIRECT OUT
MIX OUT
LINE
HPF DJ FOHMON SIGNAL CLIP TEMP
MIC/LINE
LINE LEVEL
MIC / LINE
-15 +65
M
I
C
L
I
N
E
LINE LEVEL
MIC/LINE
SIGNAL CLIP TEMP
OUTPUT 1
OUTPUT 2
INPUT 1
LOW PASS FILTER
OUTPUT LEVEL
60 Hz 80 Hz
100 Hz
INPUT 2
Natural Mono
0
OUTPUT LEVEL
DIRECT OUT
MIX OUT
LINE
HPF DJ FOHMON SIGNAL CLIP TEMP
MIC/LINE
LINE LEVEL
MIC / LINE
-15 +65
M
I
C
L
I
N
E
LINE LEVEL
SIGNAL CLIP TEMP
SIGNAL CLIP TEMP