Surface Cleaner PP-SC18 Manual

ManualsBrandsPressure-Pro ManualsGas4000PSI Deluxe Start Your Own Pressure Washing Business Kit w/ Aluminum Frame, CAT Pump & Honda GX Engine (49-State Compliant)

WARNING:

To reduce the risk of injection or injury, only use the surface

cleaner on ﬂat, horizontal surfaces. Never lift the surface

cleaner from the cleaning surface while operating the

pressure washer.

18" Surface Cleaner PP-SC18

WARNING:

To reduce the risk of injury, user must read and understand

the operator’s manual for their pressure washer before using

this accessory. Fits most pressure washers. Ensure

compatibility and proper ﬁt before using this accessory. Wear

eye protection marked to comply with Z87.1. Risk of ﬂuid

injections. Do not point at people, pets, electrical devices or

the unit itself. Turn off the pressure washer before changing or

adjusting accessories. For cold water use only. Save these

instructions. Refer to them frequently and use them to instruct

other users. If you loan someone this tool, loan them these

instructions also.

PRODUCT SPECIFICATIONS

Connections..................................3/8 in. Quick Connect Plug Inlet

Deck Width........................................................................ 18 in.

Maximum Pressure........................................................4500 PSI

Maximum Water Flow.......................................................5 GPM

Maximum Water Temperature.........................................180°F

ASSEMBLING THE SURFACE CLEANER

See Figure 1 - 4.

Place the legs of the lower handle in the mounting brackets on

the surface cleaner deck. Align the holes in the legs with the

holes in the brackets.

Insert pin through the holes in the mounting brackets and legs.

Install split ring through hole on the end of the pin to secure.

Repeat this process to secure the other leg.

Attach the upper handle to the lower handle. Secure with pin

and split ring.

Apply high strength threadlocker liquid or teﬂon tape (if needed)

to the ends of the hose.

Attach the ﬁxed end of the hose to the trigger handle inlet.

Securely tighten, but do not overtighten.

Attach the swivel end of the hose to the inlet on the top of

the

surface cleaning deck. Securely tighten, but do not overtighten.

Check the bottom of the surface cleaner deck to verify that the

nozzles are tightened securely and are aligned correctly.

SURFACE

CLEANER

SPRAY

GUN

INLET

PLUG

Fig. 3

Fig. 1

LOWER

HANDLE

LEG

MOUNTING

BRACKET

SPLIT RING

UPPER

HANDLE

LOWER

HANDLE

SPLIT

RING

Fig. 2

AFTER TIGHTENING

SECURELY,

NOZZLE OPENING SHOULD

BE POINTED

IN SAME DIRECTION AS

SPRAY BAR

NOZZLE OPENING

Fig. 4

Summary of content (2 pages)

PAGE 1
8" Surface Cleaner PP-SC18 SPLIT RING WARNING: To reduce the risk of injury, user must read and understand the operator’s manual for their pressure washer before using this accessory. Fits most pressure washers. Ensure compatibility and proper ﬁt before using this accessory. Wear eye protection marked to comply with Z87.1. Risk of ﬂuid injections. Do not point at people, pets, electrical devices or the unit itself. Turn off the pressure washer before changing or adjusting accessories.
PAGE 2
USING THE SURFACE CLEANER See Figure 5. Attach the high pressure hose of your pressure washer to the inlet plug on the surface cleaner’s spray gun. Connect the garden hose to your pressure washer and start the pressure washer as described in your pressure washer manual. Walk slowly behind the cleaning deck, cleaning as you go. NOTE: If striping or swirling occurs, slow your pace. If striping or swirling continues, the surface cleaner skirt bristles may be worn and in need of replacement.