Use and Care Manual

!
10!
-Rear Ducting Instructions-
In some cases, you will not be able to duct the unit to the top. In that case, rear
ducting is necessary.
1) Lay insert on its face on top of a soft, non-abrasive blanket.!
2) Remove the screws from the L-bracket on the blower assembly. DO NOT LOSE
SCREWS.
3) Disconnect motor wires from terminal block.!
4) Flip the unit so the exit hole is facing the back of the unit.!
5) Re-apply the screws to the L-bracket on the blower assembly.!
6) Be sure that your unit is secure and in place and available for ducting through the
back.
-Instructions for connection of optional Wall
Switch Kit (UIBWSK)-
1) Disconnect wires from Fan and Light switches from the wiring harness supplied
with your insert.
2) Connect Fan and Light switches to harness supplied with Prestige® wall switch
kit
3) Make all electrical connections between supplied harness and wires for wall
switch inside of insert electrical box
4) Before hanging your hood and wall switch kit, be sure that the connections made
are fully operational.
*Be sure to have a licensed electrician make all connections to prevent
from electric shock. By using a Wall Switch Kit you will render the on-
board controls on your ventilation hood non-operational.*