Use and Care Manual

- Handling Precautions -

• Remove all rings, watches, belt buckles, jewelry and any clothing with metal buttons or

snaps to prevent damage to the Insert.

• DO NOT REMOVE INSERT FROM ITS ORIGINAL CARTON UNTIL YOU ARE READY

TO INSTALL IT.

• When you are ready to begin the installation process, remove the insert from its carton

and place it on a clean soft blanket.

• Inspect the insert carefully for any damage or imperfections before you begin to install

the insert. If any damage or imperfections exist, re-carton the insert and call your dealer

IMMEDIATELY, do not install a damaged hood.

• It is highly recommended that rubber gloves be used to prevent scratches on the insert

and to provide you with a firm grip.

• When removing the insert from the carton locate the filters. The filters are not

pre-installed in the insert. The filters are in a box marked filters, inside the insert

carton.

• Internal blower inserts can be ducted to the top or the rear. Check product guide for

additional transitions, wall caps and roof caps.

• Duct size for units ending in 600 is 6" round and an optional transition model TRC8/6

should be used to increase the duct size to 8" round for optimal performance.

• Units with model numbers ending in 1200 require the use of transition model TR6x15/10

(NOT INCLUDED AND SOLD SEPERATELY).

• All Prestige® ventilation inserts have a variable speed blower switch as well as a light

dimmer switch.

• Inserts can be set up for ductless applications. See product guide for optional

ductless conversion kits.