Quick Start Guide

Quick Start Guide
Prestigio RoadRunner
EN
Getting started
Start recording
1. Insert a micro SD card (not included).
2. Connect the device to the car charger. When the car engine
starts, the device will begin loop recording.
Taking photos
• Press [ ] to take photos, the captured photos will be saved on
the micro SD card.
Note:
•
The italicized text in this quick start guide is only for the GPS
model.
•
The GPS receiver is built in the suction mount. Please connect the
car charger to the USB port on the mount. When the device is
connected to the GPS signal, the icon will be green.
Settings
In preview mode, press [M] to select settings mode. Use [ ]/[ ]
to navigate the menu.
Settings menu
• Resolution: Select the resolution of recorded video:
2304x1296(30 fps), 1920x1080(30 fps), 1280x720(30 fps).
• Record overwrite: Set the video duration for loop recording.
When the micro SD card is full, the device will delete the first
unlocked video file automatically.
• Motion detection: Turn on or off motion detection. If there is
any motion detected while the car engine is stopped, your car
DVR will start recording automatically.
• Power on record: Set the DVR to start recording when power
on.
• Power off delay: Select a time span for the DVR to power off
when the car engine stops.
• Power on delay: Select a time span for the DVR to power on
when the car engine starts.
• G-sensor set
: Select the sensitivity of the G-sensor.
• Car number set: Set the car plate/registration number if
necessary.
• Stamp: Add information stamp to videos/photos.
• GPS auto update time
: Set the GPS to update the date/time
automatically.
• GMT setup
: Select the local GMT (Greenwich Mean Time).
• GPS set up
: Turn on or off GPS.
• WDR: Turn on or off WDR (Wide Dynamic Range).
• Detector set up
: Turn on or off the detector.
• LDWS detect: Turn on or off LDWS (Lane Departure Warning
System).
• LDWS calibration: Adjust the LDWS.
LDWS (Lane Departure Warning System)
A lane departure warning system is a mechanism designed to
warn a driver when the vehicle begins to move out of its lane on
freeways and arterial roads.
Note: The warning system works only if the vehicle is beyond a
speed of roughly 60 km/h.
1. In settings menu, select LDWS DETECT, and then press [ ] to