Car Video Recorder RoadRunner 565 / RoadRunner 565GPS User Manual Version 1.0 www.prestigio.
About this user manual This user manual is specially designed to detail the device’s functions and features. -- Please read this manual before using the device to ensure safe and proper use. -- Descriptions are based on the device’s default settings. -- Prestigio continuously strives to improve its products. Due to software upgrading, some contents in this user manual may be different from your product.
Contents 1. Unboxing ������������������������������������������������������������������������������������������������������������������������� 1 Inside your package ����������������������������������������������������������������������������������������������������������������1 Device overview ����������������������������������������������������������������������������������������������������������������������1 2.
1.
2. Getting started Insert a microSD card Before starting video recording, please insert a microSD card (not included) into the slot until it locks in place. 2 The device will automatically recognize it as default storage and all the data will be saved on this card. Install the suction mount 1. Match the mounting slots of the device and the suction mount, and press the suction mount until it locks in place. 2.
Main screen Press power button to turn on device, you will enter preview mode, and get below screen: 1 2 3 4 5 6 Resolution Recording icon Infrared light Battery Memory card Microphone 7 8 9 10 11 12 Recording time Loop recording Motion detect Speed and GPS location Plate number and LOGO stamp Date and time When the device is connected to the GPS signal, the icon User Manual will be green.
3. Settings Before recording, you can set up the device according to your requirements. -- In preview mode, press [M] two times to enter settings, press it again to exit. Use [ ]/[ ] to navigate the menu. Press [ ] to confirm. 3 Settings menu • Resolution: Select the resolution of recorded video: 2560x1080 (30 fps), 2304x1296 (30 fps), 1920x1080 (30 fps), 1920x1080 (30 fps)(HDR), 1280x720 (60 fps), 1280x720 (30 fps). • Video quality: Set the video quality to super fine, fine, or normal.
• Detector setup: Turn on to detect if there is road camera ahead. • Firmware Version: Display the current system version. LDWS (Lane Departure Warning System) A lane departure warning system is a mechanism designed to warn a driver when the vehicle begins to move out of its lane on freeways and arterial roads. Note: System accuracy depends on lighting conditions and driving speed (optimum accuracy at speeds of approx. 60 km/h and higher.
4. Recording 4 Record a video Auto video recording Connect the device to car charger, when the car engine launches, the device will automatically turn on and start loop video recording. When shut off the car engine, the device will save the last file and turn off. You can cancel it by turning off POWER ON RECORD in settings. Manual video recording In preview mode, press [ ] button to start and stop video recording. Zoom in or out In preview mode or recording mode, press [ ]/[ ] to zoom in or zoom out.
6. Playback Play video on DVR 1. 2. 3. 4. In playback mode, press [ ] and [ ]/[ ] to select your desired video. Press [ ] to open the file, and press it again to start playing. Press [ ]/[ ] to slow down or speed up playing. Press [M] again to exit playback mode. 6 Trim a video 1. During playing, press [ ] to start or stop video trimming. 2. Press [ ] to confirm and save the trimmed video. Playback on your TV/Monitor 1. Connect the car DVR to a TV/Monitor with a HDMI cable (not included). 2.
7. Specifications 7 Display Processor Image sensor View angle 2.0", 480 x 234 pixels Amarella A7LA50D 3.0 MP CMOS 1/3" 170° 2560x1080 (30 fps), 2304x1296 (30 fps), 1920x1080 (30 fps), 1920x1080 Video resolution (30 fps)(HDR), 1280x720 (60 fps), 1280x720 (30 fps) Video codec MP4 (H.