Use and Care Manual

7. Hold the cover up to the light and

look through the vent pipe (Fig.

E) to be certain it is clear before

placing the cover on the canner. If

it is clear, proceed to step 8. If it is

blocked, clean the vent pipe and

vent pipe nut with a small brush or

pipe cleaner (Fig. F and Fig. G).

8. Check to be sure the overpressure

plug is seated properly in the cover

(see page 22, Fig. M).

9. Place cover on canner, aligning

the V mark on the cover with the

inverted V mark on the body handle

(Fig. H). Press down on the cover

handles to compress the sealing

ring and turn the cover in the direc-

tion indicated to close (clockwise)

until the cover handles are above

the body handles. Do not rotate the

cover beyond this point.

10. Position canner on a level burner

and range only. Use on a tilted

burner or range may interfere with

the operation of the pressure regu-

lator. For electric coil, smooth-top,

and induction ranges, use the ele-

ment that most closely matches the

9-inch diameter of the canner bottom. This is the portion of the

canner bottom which comes in contact with the element.

CAUTION! Do not use on any outdoor LP gas burner or a gas

range over 12,000 BTU’s. Using too large of an element or

over 12,000 BTU’s may soften the canner causing the bottom

to warp. It may also result in property damage and/or personal

injury.

READ INSTRUCTIONS

BEFORE OPERATING

psi

Fig. E

Fig. F

Fig. G

Align the V mark on the cover with the

inverted V mark on the body handle.

Fig. H