Use and Care Manual
Part 44364
Part 02704
Part 44285
4
When I press down on the pump nothing seems to be happening. What am I doing wrong?
You may not have the pump fully attached to the reservoir and air is escaping. Be sure to press all the way around the pump edge so the
ridged portion (see Fig. A, page 2) is fully engaged inside the reservoir rim.
You also may not be applying enough pressure as you are pumping. Stand so you are directly over the coffee maker and press on the
pump. Hold the pump down until the coffee ceases to ow, release and allow the pump to return to its original position, and repeat process.
Can I use both K-Cups* and lower cost cups that do not have the K-Cup* trademark?
As long as the cup is compatible with Keurig* brewing systems (other than the Keurig* Vue* brewer), it may be used with the MyJo
coffee maker. That includes the cups that have mesh bottoms. Off brand cups vary in construction. Some have very thin plastic walls that
become deformed if boiling water is used. Others have very thin interior lters, which work well with a gentle pumping pressure, but
may break when subjected to heavy pressure. Still others have very rigid tops of varying thickness, making them difcult to pierce. If
you experience unusual difculty pumping and the water in the vessel has turned brown, you have a cup with a thin lter that has broken
under pressure. Discard the liquid, clean the unit, and start again, this time applying a gentle steady pressure.
If the water is clear, verify that the top and bottom of the cup are pierced. Carefully unscrew the reservoir from the base. For cups with
plastic bottoms, push down to ensure the bottom is pierced. Check the top. If you do not see a small hole in the middle, make one with
a knife. Reassemble and resume pumping.
Sometimes I prefer to use my own coffee grounds rather than a K-Cup*. Is there a rellable lter cup that I can use with the
MyJo
coffee maker?
Yes. There is one cup that is designed to work in the MyJo
coffee maker, the MyJo
Cup. To order, call the Presto Consumer Service
Department at 1-800-877-0441. Do not use any other brand of cup.
PERFECT COMPANIONS FOR YOUR PRESTO
MYJO
COFFEE MAKER...
Presto
Heat ’n Steep
electric tea kettle (Part 02704)
This tea kettle is ideal for heating water to use in the MyJo
coffee maker. The built-in thermometer enables
you to heat water to the perfect temperature for coffee.
In addition to heating water, this versatile ve-cup tea kettle also steeps most any type of tea—green, white,
oolong, black, red, and herbal teas. The color-coded temperature guide enables you to determine the point
at which the water is at the correct temperature for brewing each type. A special infuser for loose tea or tea
bags locks on to the tea kettle lid when the water is at the correct temperature, or alternatively can be used
in a cup to brew an individual serving of tea. The kettle’s built-in electronic timer is then set to the exact
steeping time required for the specic tea being brewed.
Presto
MyJo
Cup (Part 44364)
Use this cup with your MyJo
coffee maker to make coffee or tea from your favorite ground coffee or tea leaves.
Presto
Coffee measuring scoop (Part 44285)
This handy 2 tablespoon scoop is perfect for measuring your favorite ground coffee for use in the MyJo
Cup.
Sold in sets of two.
How to Order...
Call toll-free 1-800-995-9960** (weekdays between 8:00 am and 4:00 pm Central Time). Please have your
credit card number and expiration date ready.
**Payment options on telephone orders limited to credit cards only.
* “K-Cup”, “Keurig”, and “Vue” are registered trademarks of Keurig, Inc. Presto is not afliated with Keurig, Inc.