Instructions / Assembly

3
How to Install Legs and Handles
Tools Required: Phillips type screwdriver
Parts Included: 4 Legs
2 Handles
To Install Legs
1. Place multi-cooker upside down on table or counter.
2. Using the screwdriver, remove the screws from each of the four mounting projections
on the bottom of the unit. These screws are for attaching the legs to the multi-cooker
base.
3. Position one of the legs, with the rubber insert facing up, over one of the mounting
projections (Fig. A). Align the hole in the leg with the hole in the mounting
projection and fasten securely with screw. Leg should not rock or move if twisted.
Caution: Overtightening can result in stripping of screws or cracking of legs.
4. Repeat step 3 for other three legs.
5. Turn multi-cooker right side up on table or counter. When properly assembled, the
multi-cooker should sit level with no leg rock.
To Attach Handles to Base
1. With multi-cooker upside
down on table or counter,
remove the screws from the
tabs on each side of the multi-
cooker base. These screws are
for attaching the handles to the
base.
Hint: When removing the
screw under the heat control
receptacle, hold the screw-
driver at a slight angle or use
a short screwdriver or a screw-
driver with a long shank.
2. Slide one of the handles, with
the screw hole facing up, onto
the tab so the screw hole on
the tab aligns with the screw hole on the handle (Fig. A). Fasten with screw and tighten
fully. Handle should not wobble or move when grasped. Caution: Overtightening can
result in stripping of screws or cracking of handles.
3. Repeat step 2 for other handle.
4. When properly installed, the handles should appear level with the table or counter.
Leg
Mounting
projection
Screw
Rubber
insert
Handle
Tab
Screw
Tab
Screw
hole
Fig. A
Heat
control
receptacle
72-743A_5Qt._KK_instr.indd 3 2/3/09 2:56:17 PM