User Manual

2
Important Cord and Plug Information
A short power supply cord (or cord set) is provided to reduce the risk resulting from becoming entangled in or tripping over a longer
cord. DO NOT USE WITH AN EXTENSION CORD.
Do not allow the cord to run underneath or around the unit. The magnetic cord may not detach easily if the cord is positioned in this fashion.
Thisappliancehasapolarizedplug(onebladeiswiderthantheother).Toreducetheriskofelectricshock,thisplugisintendedtot
intoapolarizedoutletonlyoneway.Iftheplugdoesnottfullyintotheoutlet,reversetheplug.Ifitstilldoesnott,contactaqualied
electrician. Do not attempt to modify the plug in any way.
Connect the power supply cord to a 120VAC electrical outlet only.
How to Install Legs and Handles
Tools Required: Phillips type screwdriver
Parts Included: 4 Legs, 2 Handles
To Install Legs to Base
1. Place multi-cooker upside down on table or counter.
2. Using the screwdriver, remove the screws from each of the four mounting projections on the bottom of the unit. These screws are
for attaching the legs to the multi-cooker base.
3. Position one of the legs, with the rubber insert facing up, over one of the mounting projections (Fig. A). Align the hole in the leg with
the hole in the mounting projection and fasten securely with screw. Leg should not rock or move if twisted.
NOTICE: Continuing to tighten, once secure, can result in stripping of screws or cracking of legs.
4. Repeat step 3 for other three legs.
5. Turn multi-cooker right side up on table or counter. When properly assembled, the multi-cooker should sit level with no leg rock.
To Attach Handles to Base
1. With multi-cooker upside down on table or counter, remove the screws from the tabs on each side of the multi-cooker base. These
screws are for attaching the handles to the base.
Hint: When removing the screw under the plug guard, hold the screwdriver at a slight angle or use a short screwdriver or a screw-
driver with a long shank.
2. Slide one of the handles, with the screw hole facing up, onto the tab so the screw hole on the tab aligns with the screw hole on the
handle (Fig. A). Fasten with screw and tighten fully. Handle should not wobble, but slight movement from side to side is normal.
NOTICE: Continuing to tighten, once secure, can result in stripping of screws
or cracking of handles.
3. Repeat step 2 for other handle.
4. When properly installed, the handles should appear parallel with the table or
counter.
To Attach Basket Handle
1. Slide lock bar up on handle (Fig. B) and place one of the handle bars into one
ofthetabsonbracket.Thensqueezethehandlebarstogetherandttheother
handle bar into the opposite tab on bracket.
2. After attaching handle to basket, make sure to slide lock bar down (Fig. C)
to the locked position to insure against accidental detachment of handle from
basket.
Before First Use
Become familiar with the various parts of the multi-cooker
(Fig. D, page 3) and read the instructions carefully. Prior to
therstuse,washthemulti-cookeraccordingtothe“Care
and Cleaning” instructions starting on page 4.
Leg
Mounting
projection
Screws
Rubber
insert
Handle
Tab
Screw
hole
Fig. A
Plug
guard
Lock
bar
Lock
bar
Fig. C
Fig. B
Tab
Handle
bar
Screw