User's Manual

7. Slide switch (17) selects the operating mode.
a. Normal mode is for driving digital motors. The bargraph displays the lens
position and any limits the user has set.
b. Video mode is for driving the internal motor of video lenses. The bargraph
indicates the information sent to the lens: the length of the illuminated bars is
proportional to the zoom velocit
y (not position as for “Normal” mode). A
“video” cable must be used to connect the video lens to the MDR2 or V+F Lens
control.
8. The LED above the POWER switch glows solid red to indicate normal operation. The LED
will flash when less than 15% of the battery charge remains. Install a charged battery at
this time.
9. Zoom Drift. The Micro Force may need occasional adjustment to eliminate zoom drift
(the zoom motor moves slowly without any pressure on the joystick). This drift can be
cancelled by simultaneously pressing both the SET and RESET buttons.
10. The Radio Micro Force can be reset to its default state by:
a. Power down the unit.
b. Hold down the RESET button and press the POWER button. Release both
buttons.
This will erase any memorized limits or offsets.
3.0 Specifications:
Size: 100mm x 77mm x 28mm (4” x 3” x 1.2” )
Weight: RMF module: 340g (12 oz)
Bracket: 130g (4.5 oz)
Typical operating time: 8 hours
Battery Type: 7.4V 1.8AH (FM50 enhanced type)
Charger: Sony BC-VM50 with US standard line plug.
Charger Operating voltage 100 – 240 VAC.
Charge Time: 4.5 hours
Product Numbers:
4015 RMF with cable for Digital Micro Force
4016 RMF with cable for Micro Force V+F2
4017 RMF cable (spare) for Digital Micro Force
4018 RMF cable (spare) for Micro Force V+F2
4915 FM50 Li-Ion Battery (spare)
4916 Charger for FM50 battery w/ US standard line cord
14
16
15