User's Manual

13
The 3D mode display (left, below) has a Set-Up soft key. Pressing this key allows the user
to input the
maximum values
The camera offset value is the distance from the pivot point of the convergence axis to the
lens nodal point. Please refer to the reference drawing for 3D rigs on page 21.
for Inter-ocular separation and Convergence angle.
Returning to the main display screen, pressing the Fshow soft-key shows the Convergence
Distance, Convergence Angle and Inter-ocular distance.
8. The System Menu reports the installed firmware version, scans for other FI+Z systems
operating in the vicinity, sets-up the operating mode for the LED’s that illuminate the
focus rings, and specifies the focus distance units ( imperial/metric).
Press the ENTER key (fig.1) to see the System Info screen (fig. 2). Press Units (fig.1) to
change between imperial and metric units (fig.3).
The System Info (fig.2) menu provides the Network scanning function and the Light set-
up for the focus ring.
Press the Network soft key (fig.2) to display a list of active FIZ systems in the vicinity. The
Occupied Channels list shows both the Occupied Channels and their signal strengths.
Press the Light soft key (fig.2) to display the options for the focus ring (fig.5).
The Auto option turns on the light automatically under dim conditions. The options may
be selected by using the Nav key to highlight the desired choice.
Fig.1 Fig. 2 Fig. 3
Fig.4 Fig.5
3D Mode selection 3D Set-Up Main Display for 3D Mode