Use Instructions

3
WARNINGS & CAUTIONS
 The head impact monitor is not a replacement, substitute or adjunct of any existing methods
for identifying athletes for evaluation due to head impacts. The head impact monitor does
not indicate, diagnose or assist in diagnosis of a concussion. Impact data is used to indicate
to staff that an impact event has occurred and reliably measure it.
 The head impact monitor does not provide any protection against head impacts.
 Before every use, inspect the product to ensure no damage to the seal of the circuit board is
evident. Discontinue use if damage is seen.
 Before every use, inspect the product to ensure no damage to the battery or seal around the
battery is evident. Discontinue use if damage is seen.
 Ensure that the impact monitor mouthguard is not subject to temperatures higher than
100 C (212 F). Ensure that the impact monitor mouthguard is not subject to 60 - 100 C
(140 - 212 F) for more than 1 minute.
 Use only the wireless charger provided with the product for charging.
 Avoid cross contamination of impact monitor mouthguards.
 Clean the impact monitor mouthguard by either rinsing in cold water or using a toothbrush to
remove debris while rinsing. Do not use toothpaste or detergents, and do not place in
dishwasher or under hot water.
 Do not leave the impact monitor mouthguard in a hot vehicle in direct sunlight.
 Do not place the impact monitor mouthguard in microwave.
 Do not operate charger outdoors.
Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Per FCC 15.21, users should not change or modify to the product.
FCC ID 2AUV5IMM1-3