Installation & Assembly

ManualsBrandsPrevue Hendryx ManualsAll Bird CagesBird Cage with Removable Tray

Parakeet Home

Model: # 98001 / 22006Y

Instructions online at www.prevuepet.com

read first REVIEW BEFORE ASSEMBLY

• No tools are required for assembly

• For best results, follow the Steps

in the order they are presented

For assistance or replacement parts,

please contact Prevue Pet Products:

PHONE 312.243.3624

ONLINE www.prevuepet.com

EMAIL customerservice@prevuepet.com

ECONO-1818 — 02/17 — USL Made in China for Prevue Pet Products, Inc., 224 N Maplewood Ave, Chicago IL 60612 USA • www.prevuepet.com • 1 [312] 243-3624 • customerservice @ prevuepet.com

To assemble the CAGE BODY,

you will need these pieces:

To add the mesh body to the

BASE

, you will need these

pieces:

Attach the back panel to the three-panel unit:

Start in the lower corner. Hook the right-side panel onto

the back panel, then weave the alternating hooked wires

of the two panels together, up the seam, to the top.

Repeat the method with the opposite seam

(left-side panel to back panel).

Set the assembled mesh

into the base, catching the

bottom wire of the side

panels under the tabs along

the rim.

Set the grille into the base.

Push the tray into the base.

Summary of content (2 pages)

PAGE 1
Parakeet Home read first REVIEW BEFORE ASSEMBLY • No tools are required for assembly Model: # 98001 / 22006Y • For best results, follow the Steps in the order they are presented Instructions online at www.prevuepet.com 1 PHONE 312.243.3624 ONLINE www.prevuepet.com EMAIL customerservice@prevuepet.com To assemble the CAGE BODY, you will need these pieces: Attach the back panel to the three-panel unit: Start in the lower corner.
PAGE 2
3 To add the ACCESSORIES, you will need these pieces: Insert the two perches on horizontal wires, at a level height. Assemble the two-piece cups, slide the cup doors open and insert the cups into the openings. 4 To add the ROOF, you will need this piece: ECONO-1818 — 02 /17 — USL Start at the side. Center the roof on the cage. Catch the second wire of the roof under the loops on the side panel. Softly bend the roof mesh to catch the roof line onto the front and back panel loops.