User Manual 3.6 Instruction Manual

VX76 SOFTWARE USER MANUAL 285
Add/Solo Mode
The Add/Solo mode provides two types of bump action, depending on what button is pressed:
+ Add - [Go] button. This function behaves like a momentary Submaster selection. When the [Go] button is pressed,
all parameters bump as if the submaster is selected.
+ Solo - [Back] button. This function behaves like a momentary Submasters selection, plus all other submaster
faders go to zero. When the [Back] button is pressed, the submaster’s parameters bump and all other
sumbaster’s parameters go to zero.
Example:
Step 1. Set submaster to Add/Solo mode (see previous page). [Select] will begin flashing.
Step 2. Press [Go] button to execute an add bump or press [Back] to execute a solo bump.
Go Fader Mode
When in the Go Fader mode, moving a Submaster’s fader above zero behaves like a Submaster selection where all
parameters bump. This action is identical to the Add/Solo mode, except the action is initiated by the fader instead of
by a button press.
Example:
Step 1. Set submaster to Go Fader mode (see previous page). [Select] will begin flashing.
Step 2. Move fader up to execute bump action.
Step 3. Move fader down to release.