User Manual 3.6 Instruction Manual

VX76 SOFTWARE USER MANUAL 75
Command-line entry guidelines:
+ When entering command lines, it is not necessary to specify channel information if the required channels are
already selected. If new channels are selected for modification on the keypad, this is reflected at the Channel
Select panel.
+ [Clear] functions as a backspace key when used during command-line construction. [Clear] is the only thing that
clears a syntax error. (Any other keypad entry is ignored until the error condition is cleared.)
+ When working from the command-line keypad, parameters will assume their new values at full speed unless
Manual Timing is currently enabled, in which case they will use their current timing values. Only when used with
the Sneak function can the keypad selections be assigned discrete timing values.
+ Since manual control requires channel selection, this can also be done using the command-line keypad. Refer to
Channel Select "From Keypad" on page 56.
Holding down [Clear] will clear an entire unterminated command line.
store color 8
Store Color 8
*
sel recall preset 15
Recall Preset 15
*
Tip