Owner`s manual

Quantum Q4 www.quantumrehab.com 19
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position of the controller for either left-
hand or right-hand use.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller harness
on the outside of the armrest pad. Route the
harness under the armrest or toward the inside
of the armrest pad. Use correct tie-down
points for the controller harness to prevent the
harness from getting caught in the drive tires,
pinched in the seat frame, or damaged when
passing through doorways.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the front of the power
base. See figure 3.
3. Remove any wire ties securing the controller harness to the
armrest.
4. Loosen the adjustment knob on the armrest where the
controller is currently located. See figure 18.
5. Relocate the controller to the desired armrest and tighten
the adjustment knob to secure the controller.
6. Use wire ties to secure the controller harness to the armrest.
7. Route the controller harness to the front of the power base
and reconnect the controller. See figure 19.
NOTE: If your power chair is equipped with a Synergy Seat
or TRU-Balance Power Positioning System, refer to the infor-
mation provided in supplemental manuals provided with your
seating system.
V. COMFORT ADJUSTMENTS
Figure 18. Controller Position
Figure 19. Cable Routing
Positioning Belt
Your power chair may be equipped with a positioning belt that can be adjusted for operator comfort. See figure 20
or 21. The positioning belt is designed to support the operator so that he/she does not slide down or forward in
the seat. The positioning belt is not designed for use as a restraining device.
WARNING! The positioning belt is not designed for use as a seat belt in a motor vehicle unless
your power chair is equipped and properly secured with a manufacturer-installed transit
securement package. Nor is your power chair suitable for use as a seat in any vehicle. Anyone
traveling in a vehicle should be properly belted into seats approved by the vehicle manufacturer.
WARNING! The positioning belt should be secured at all times. Never allow the positioning belt
to hang or drag on the floor as it may become entangled.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through the positioning belt and into the seat base for each side
of the power chair seat.
3. Tighten both screws.
Note: If your power chair is equipped with an optional seating system, please refer to the user manual provided
with the seat for instructions on positioning belt installation or contact your Quantum Rehab Provider.