Backpacker
SAFETY GUIDELINES The symbols below are used throughout this owner's manual and on the product to identify warnings and important information. It is very important for you to read them and understand them completely. WARNING! Failure to follow designated procedures can cause either personal injury, component damage, or malfunction (black symbol on yellow triangle with black border). MANDATORY! These actions should be performed as specified.
C O N T E N T S I. INTRODUCTION......................................................................................................................... 4 II. SAFETY ......................................................................................................................................... 6 III. INSTALLATION .......................................................................................................................... 8 IV. OPERATION ............................................
I . INTRODUCTION Welcome to Pride Mobility Products Corporation (Pride). Congratulations on the purchase of your new Backpacker Lift System. The Backpacker Lift System design combines the most advanced state-of-the-art components with modern, attractive styling. We are certain that the design features and trouble-free operation will add convenience to your daily living and ensure complete satisfaction. At Pride, your safety is important to us.
I . INTRODUCTION PRIDE OWNERS CLUB As an owner of a Pride product, you are encouraged to enroll in the Pride Owners Club. Complete and return your enclosed product registration card or visit Pride’s web site at www.pridemobility.com. As a registered member, each time you visit our site, you have access to the most interactive, educational venue available today for people with mobility needs, their families, and friends.
II. SAFETY PRODUCT SAFETY SYMBOLS The symbols below are used on the lift system to identify warnings, mandatory actions, and prohibited actions. It is very important for you to read and understand them completely. Crush Hazard—Pinch/crush points created during assembly and operation. Keep hands clear. Crush Hazard—Moving parts can crush and cut. Keep hands clear. Crush Hazard—Moving lift can crush. Keep feet clear during operation.
II. SAFETY LIFTING CAPABILITIES The Backpacker Lift System is designed for a maximum lifting capacity of 325 lbs. (147 kg). Under no circumstances should the Backpacker Lift System be made to exceed this weight limit. Subjecting the lift system to the strain of hoisting more than it is designed to lift may cause it to fail, resulting in damage to the mobility device and/or the lift operator.
III. INSTALLATION BACKPACKER LIFT SYSTEM INSTALLATION WARNING! Prevent product and/or vehicle damage! The Backpacker Lift should be installed by an authorized service technician only. NOTE: Use only the supplied hardware to install the Backpacker Lift System. NOTE: If you are installing the Backpacker into a full-sized van, refer to the information provided in separate literature for side-entry securement system installation.
III. INSTALLATION TOWER MICROSWITCHES STOP BLOCK TRUCK FRAME LOCKING PLATE TRUCK MICROSWITCH Figure 2. Backpacker Installation 6. Remove the shipping cleat from the Backpacker stop block and discard it and the mounting nut. 7. Install the bolt you removed from the shipping cleat into the stop block on the Backpacker and secure with the supplied nut. See figure 2. 8. Connect the Backpacker wiring harness to the hand control. 9.
III. INSTALLATION 14. Simultaneously press the two microswitches on the Backpacker tower arm and the “DOWN” button on the hand control until the tower reaches its full extension. See figure 2. 15. Release the microswitches, then press the “UP” button on the hand control to retract the tower arm. 16. Insert the T-Bar into the lift tower and secure into position with the supplied hardware. See figure 3. 17. Push the “UP” button on the hand control to raise the platform frame to its highest position. 18.
III. INSTALLATION WARNING! Release the “DOWN” button when the lift platform touches the ground. Do not allow the motor to run after the lift platform has touched the ground. Allowing the motor to run will increase the pressure on the lift platform and may result in product or vehicle damage. Wiring Harness Installation The wiring harness is approximately 25 ft. (7.62 meters) long and will accommodate most vehicles. NOTE: You may wish to perform a practice run before installing the wiring harness.
III. INSTALLATION 6. Reinstall the 15-amp fuse to the wiring harness. WARNING! Before operating the lift, inspect the wiring harness for proper routing and grounding. Improper routing can cause damage to the harness, and improper grounding can cause damage to the electrical system. PROTRUDING BOLTS Onboard Battery Installation The optional onboard battery is designed for easy installation as it does not require any wires to be routed through or under the vehicle.
I V. OPERATION BACKPACKER LIFT SYSTEM OPERATION The Backpacker Lift System is designed to lift an unoccupied mobility device from the ground and into the cargo area of a full-sized or mini van for the purpose of easy transport. WARNING! The Backpacker Lift System is intended for the transport of unoccupied mobility devices only. Do not sit on mobility device while activating lift or during transport. Follow these steps to load a mobility device with the Backpacker Lift System: 1.
I V. OPERATION WARNING! Prevent product damage! Never attempt to secure the Y-strap over the seatback or armrests of the mobility device. 5. Pull the end of the strap tightly to remove any excess slack over the seat. NOTE: Inspect the Y-strap before each use to ensure there are no signs of fraying or wear. Ensure that the mobility device is secured properly before transport. Pride is not liable for damage or loss resulting from improper securing of a mobility device. 6. Press and hold the “UP” button.
V. BATTERY CHARGING BATTERY CHARGING Follow these steps to charge the onboard battery: 1. Remove the onboard battery from the battery case and place it near a standard electrical wall outlet. 2. Remove the cap from the charger socket located on the bottom of the battery, plug the charger cord into the charger socket, then connect the charger cord to a standard electrical outlet. See figure 9. PROHIBITED! Never use an extension cord to plug in your charger cord.
VI. CARE AND MAINTENANCE CARE AND MAINTENANCE Your lift system requires a minimal amount of care and maintenance. If you do not feel confident in your ability to perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.
VI. CARE AND MAINTENANCE BATTERY BOX BATTERY SECUREMENT STRAP BATTERY SECUREMENT BRACKET BATTERY CONNECTOR Figure 11. Battery Replacement Backpacker www.pridemobility.
VII. TROUBLESHOOTING TROUBLESHOOTING Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge. What if the motor on my lift system will not operate? ! Make sure the onboard battery or vehicle battery is fully charged.
VIII. Lift System Dimensions Total Lift System Weight Base Lift Weight Maximum Lift Capacity Mobility Device Dimensions Maximum Lift Travel Distance Motor Onboard Battery Charger SPECIFICATIONS SPECIFICATIONS Overall Length: 46 in. (117 cm) Overall Width (including platform): 47 in. (119.4 cm) Overall Height: 38 in. (96.5 cm) Platform Length: 47 in. (119.4 cm) Platform Width: 27 in. (68.6 cm) 155 lbs. (70 kg) including standard platform 98 lbs. (44.5 kg) 325 lbs. (147 kg) Length: 47 in. (119.
IX. WARRANTY THREE-YEAR TRANSFERABLE LIMITED WARRANTY For three (3) years from the date of purchase, Pride Mobility Products will repair or replace at our option, free of charge, any mechanical or electrical component found upon examination by an authorized representative of Pride to be defective in material and/or workmanship. This warranty does not extend to those items, which may require replacement due to normal wear and tear.
N OT E S Backpacker www.pridemobility.
NOTES 22 www.pridemobility.
*INFMANU3109*
