Owner`s manual

Travel Pal www.pridemobility.com 31
Any electromechanical device requires occasional troubleshooting. However, most problems that arise can usually
be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not
fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your Travel Scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic beep code will sound in the event one of the conditions listed below develops.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel
Scooter has been turned off, then turned back on.
VIII. BASIC TROUBLESHOOTING
1,1 1. Temperature >92°C or < -25°C. Let your Travel Scooter cool or move it to
2. Excessive load on vehicle. a warmer place. If necessary, push the main
3. Operation in extreme environments. circuit breaker reset button.
4. Electromagnetic brake not releasing.
1,2 1. Throttle input wire open or shorted.
2. Throttle pot defective. Contact your authorised Pride Dealer.
3. Wrong throttle type selected.
1,4 1. Battery voltage <16 volts. Charge batteries and/or check connections.
2. Bad connection at battery or
controller.
1,5 1. Battery voltage >32 volts.
2. Vehicle operating with charger Disconnect charger.
attached. Check battery connections.
3. Intermittent battery connection.
2,1 1. Main contactor driver failed open. Contact your authorised Pride Dealer.
2,3 1. Main contactor welded or stuck
open. Contact your authorised Pride Dealer.
2. Main contactor driver fault.
3. Brake coil resistance too high.
2,4 1. Main contactor driver failed closed. Contact your authorised Pride Dealer.
3,1 1. Misadjusted throttle.
2. Broken throttle pot or throttle Contact your authorised Pride Dealer.
mechanism.
3,2 1. Electromagnetic brake driver Turn key to off position, then push freewheel
shorted. lever to drive mode and restart Travel Scooter.
2. Electromagnetic brake coil open.
BEEP CODE POSSIBLE CONDITIONS SOLUTION