Operation Manual

26 www.pridemobility.com Celebrity X
V. BATTERIES AND CHARGING
How can I get maximum range or distance per charge?
Rarely will you have ideal driving conditions—smooth, flat, hard driving surfaces with no wind or curves. Often,
you will face hills, pavement cracks, uneven and loosely packed surfaces, curves and wind, all of which affect the
distance or running time per battery charge. Below are a few suggestions for obtaining the maximum range per
battery charge.
 Always fully charge your scooter’s batteries prior to daily use.
 Maintain 2-2.4 bar in each tire.
 Plan your route ahead to avoid as many hills, cracked, broken, or soft surfaces as possible.
 Limit your baggage weight to essential items.
 Try to maintain an even speed while your scooter is in motion.
 Avoid stop-and-go driving.
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both AGM and Gel-Cell are deep-
cycle batteries that are similar in performance. Do not use wet-cell batteries, which have removable caps.
WARNING! Corrosive chemicals are contained in batteries. Use only AGM or Gel-Cell
batteries to reduce the risk of leakage or explosive conditions.
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
How do I change a battery in my scooter?
WARNING! Battery posts, terminals and related accessories contain lead and lead
compounds. Wash hands after handling.
WARNING! Prevent injury and/or equipment damage! Do not mix or match new and old
batteries. If you encounter a situation where one battery needs to be replaced, then replace
both batteries. Refer to specifications table in this manual and the manual supplied with
the battery charger for recommended type and capacities.
1. Remove the seat and rear shroud.
2. Disconnect the battery tie-down strap.
3. Disconnect the battery harness by pulling it straight up. See figure 13.
4. Disconnect the battery cables from the battery terminals.
5. Remove the old battery.
6. Place a new battery in the battery well. Face the battery terminal towards the seat post.
7. Connect the red battery cable to the positive (+) battery terminal.
8. Connect the black battery cable to the negative (-) battery terminal.
9. Reconnect the battery harness.
10. Reconnect the battery tie-down strap. See figure 13A.
11. Reinstall the rear shroud and seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and
contact your authorized Pride Provider for instructions on disposal and the necessary information on
battery recycling, which is our recommended course of action.